V-Belts - Remove and Install
Show/hide table
Illustration 1 | g00540870 |
Typical example |
- Loosen all of the bolts that fasten the fan guard assembly to the fan shroud. Remove fan guard assembly (1) from the fan shroud.
- Loosen bolts (2) and slide alternator (3) toward the engine.
- Maneuver V-belts (4) around the fan and remove the V-belts.
Note: Never replace one V-belt. Always replace sets of V-belts, if equipped.
Show/hide table
Illustration 2 | g00540870 |
Typical example |
- Install V-belts (4) behind the fan and on the correct pulleys.
- Slide alternator (3) away from the engine. Tighten bolts (2) and check the belt tension. Refer to Specifications , RENR2401, "Belt Tension Chart" for the correct belt tension.
Note: If the V-belt cannot be checked with a gauge, press on the V-belt at the center of the longest free length in order to check the deflection. Under a moderate amount of pressure, the V-belt should have a deflection of
10.0 mm (0.40 inch) . - Put fan guard assembly (1) in position on the fan shroud. Install the bolts that fasten the fan guard assembly to the fan shroud.
Caterpillar Information System:
3304B and 3306B Engines for Caterpillar Built Machines Spacer Plate - Remove and Install
3606 and 3608 Engines Pressure Contactor
G3408 and G3412 Engines Piston and Rings - Gallery Piston
3412E and C30 Marine Engines Model View Illustrations
Installation Of The 170-3519 Timing Calibration Harness Assembly {1900, 1905} Installation Of The 170-3519 Timing Calibration Harness Assembly {1900, 1905}
3054 Truck Engine Idle RPM - Check/Adjust
3412E, C30 and C32 Marine Engines Turbocharger - Remove
3054 Truck Engine Engine Crankcase Breather - Clean
G3408 and G3412 Engines Connecting Rod
3412E and C30 Engines Front Power Take-Off (FPTO)
3612 and 3616 Engines Probe Adapter
3612 and 3616 Engines Probe Adapter
3612 and 3616 Engines Engine Speed Sensor
3606 and 3608 Engines Temperature Contactor
G3606 and G3608 Engines Fuel Control Valve - Remove and Install
3054 Engine for Caterpillar Built Machines Camshaft Gear - Remove and Install
3606 and 3608 Engines Temperature Contactor
3500 Locomotive Engines Temperature Contactor - Coolant
3054B Industrial Engine Crankshaft - Remove - 3054 and 3054B Engines
G3606 and G3608 Engines Exhaust Bypass - Remove
3606 and 3608 Engines Temperature Contactor - Coolant
G3606 and G3608 Engines Exhaust Bypass - Disassemble
3606 and 3608 Engines Temperature Contactor
3612 and 3616 Engines Pressure Contactor