Idle RPM - Check/Adjust
Show/hide table
| NOTICE |
|---|
These adjustments are to be made only by a Caterpillar dealer or a mechanic that has the correct training. A governor set point that is incorrectly adjusted could result in excessive fuel consumption or premature engine component wear. |
Slow engine response and low power may indicate a need for adjustment or repair. This adjustment should not be made by untrained personnel. Your Caterpillar dealer is equipped to perform this service.
Caterpillar Information System:
3412E, C30 and C32 Marine Engines Turbocharger - Remove
3054 Truck Engine Engine Crankcase Breather - Clean
G3408 and G3412 Engines Connecting Rod
3412E and C30 Engines Front Power Take-Off (FPTO)
3612 and 3616 Engines Probe Adapter
3612 and 3616 Engines Probe Adapter
3612 and 3616 Engines Temperature Sensor
3612 and 3616 Engines Air Inlet Elbow
3408E and 3412E Engines for Caterpillar Built Machines Injection Actuation Pressure Sensor - Remove and Install
3412E, C30 and C32 Marine Engines Atmospheric Pressure Sensor - Remove and Install
3412E, C30 and C32 Marine Engines Engine Oil Temperature Sensor - Remove and Install
3412E, C30 and C32 Marine Engines Fuel Temperature Sensor - Remove and Install
Installation Of The 170-3519 Timing Calibration Harness Assembly {1900, 1905} Installation Of The 170-3519 Timing Calibration Harness Assembly {1900, 1905}
3412E and C30 Marine Engines Model View Illustrations
G3408 and G3412 Engines Piston and Rings - Gallery Piston
3606 and 3608 Engines Pressure Contactor
3304B and 3306B Engines for Caterpillar Built Machines Spacer Plate - Remove and Install
3054 Engine for Caterpillar Built Machines V-Belts - Remove and Install
3612 and 3616 Engines Engine Speed Sensor
3606 and 3608 Engines Temperature Contactor
G3606 and G3608 Engines Fuel Control Valve - Remove and Install
3054 Engine for Caterpillar Built Machines Camshaft Gear - Remove and Install
3606 and 3608 Engines Temperature Contactor
3500 Locomotive Engines Temperature Contactor - Coolant