Engine Speed Sensor
Show/hide table
图 1 | g00570604 |
典型实例 |
(1) 发动机转速传感器
(2) 飞轮齿圈
按以下步骤调整飞轮齿圈和发动机转速传感器的间隙。
- 发动机停止时,检查齿轮的轮齿位置。 确保飞轮齿圈的轮齿集中在发动机转速传感器的开口处。
- 拆下发动机转速传感器。 确保发动机转速传感器与飞轮齿圈的轮齿相接触。
注: 有些发动机转速传感器具有平坦底盘,有些则具有小齿尖。 如果发动机转速传感器具有小齿尖,确保齿尖与齿轮的轮齿中心(最高点)相接触。
- 拧松发动机转速传感器。
按下列圈数拧松发动机转速传感器。 ... 1 至 1 1/4 圈
- 拧紧锁定螺母。
将锁紧螺母拧紧至以下扭矩。 ... 45 ± 7 N·m (33 ± 5 lb ft)
调整后的间隙范围应如下所示。 ... 1.69 ± 0.14 mm (0.067 ± 0.006 inch)
Caterpillar Information System:
3054 Engine for Caterpillar Built Machines V-Belts - Remove and Install
3304B and 3306B Engines for Caterpillar Built Machines Spacer Plate - Remove and Install
3606 and 3608 Engines Pressure Contactor
G3408 and G3412 Engines Piston and Rings - Gallery Piston
3412E and C30 Marine Engines Model View Illustrations
Installation Of The 170-3519 Timing Calibration Harness Assembly {1900, 1905} Installation Of The 170-3519 Timing Calibration Harness Assembly {1900, 1905}
3054 Truck Engine Idle RPM - Check/Adjust
3412E, C30 and C32 Marine Engines Turbocharger - Remove
3054 Truck Engine Engine Crankcase Breather - Clean
G3408 and G3412 Engines Connecting Rod
3412E and C30 Engines Front Power Take-Off (FPTO)
3612 and 3616 Engines Probe Adapter
3606 and 3608 Engines Temperature Contactor
G3606 and G3608 Engines Fuel Control Valve - Remove and Install
3054 Engine for Caterpillar Built Machines Camshaft Gear - Remove and Install
3606 and 3608 Engines Temperature Contactor
3500 Locomotive Engines Temperature Contactor - Coolant
3054B Industrial Engine Crankshaft - Remove - 3054 and 3054B Engines
G3606 and G3608 Engines Exhaust Bypass - Remove
3606 and 3608 Engines Temperature Contactor - Coolant
G3606 and G3608 Engines Exhaust Bypass - Disassemble
3606 and 3608 Engines Temperature Contactor
3612 and 3616 Engines Pressure Contactor
G3606 and G3608 Engines Exhaust Bypass - Assemble