Spacer Plate - Remove and Install
拆卸步骤
开始:
- 拆卸缸盖。 请参考解体与组装, "缸盖 - 拆卸"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 从间隔板 (2) 上拆下 O 型密封圈 (1) 、水封 (3) 和导水器 (4) 。
Show/hide table
图 1 | g00540847 |
- 从缸盖上拆下间隔板 (2) 。
Show/hide table
图 2 | g00540857 |
Show/hide table
注意 |
---|
拆下隔套板时不要损坏定位销。 |
- 从缸盖上拆下 O 型密封圈 (6) 和间隔板密封垫 (5) 。
Show/hide table
图 3 | g00540895 |
安装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 彻底清洗间隔板与缸体之间的配合面。
- 安装新的间隔板密封垫 (5) 和新的 O 形密封圈 (6) 。
Show/hide table
图 4 | g00540895 |
- 将间隔板 (2) 安装到缸盖上。
注: 如果因任何原因缸体上的定位销已拆下,安装的总高度为 16.0 ± 5.0 mm (.63 ± .20 in)。
Show/hide table
图 5 | g00540857 |
注: 间隔板、间隔板密封垫以及缸体顶部的表面必须干净且干燥。 不要在这些表面上使用任何密封垫粘合剂或其它物质。
- 安装新的 O 型密封圈 (1) 。 安装新的水封 (3) 。 安装新的导水器 (4) 。
Show/hide table
图 6 | g00540847 |
- 检查缸套凸出量。 请参考解体与组装, "缸套 - 安装"。
End By: 安装缸盖。 参考 解体与组装, "缸盖- 安装"。
Caterpillar Information System:
3606 and 3608 Engines Pressure Contactor
G3408 and G3412 Engines Piston and Rings - Gallery Piston
3412E and C30 Marine Engines Model View Illustrations
Installation Of The 170-3519 Timing Calibration Harness Assembly {1900, 1905} Installation Of The 170-3519 Timing Calibration Harness Assembly {1900, 1905}
3054 Truck Engine Idle RPM - Check/Adjust
3412E, C30 and C32 Marine Engines Turbocharger - Remove
3054 Truck Engine Engine Crankcase Breather - Clean
G3408 and G3412 Engines Connecting Rod
3412E and C30 Engines Front Power Take-Off (FPTO)
3612 and 3616 Engines Probe Adapter
3612 and 3616 Engines Probe Adapter
3612 and 3616 Engines Temperature Sensor
3054 Engine for Caterpillar Built Machines V-Belts - Remove and Install
3612 and 3616 Engines Engine Speed Sensor
3606 and 3608 Engines Temperature Contactor
G3606 and G3608 Engines Fuel Control Valve - Remove and Install
3054 Engine for Caterpillar Built Machines Camshaft Gear - Remove and Install
3606 and 3608 Engines Temperature Contactor
3500 Locomotive Engines Temperature Contactor - Coolant
3054B Industrial Engine Crankshaft - Remove - 3054 and 3054B Engines
G3606 and G3608 Engines Exhaust Bypass - Remove
3606 and 3608 Engines Temperature Contactor - Coolant
G3606 and G3608 Engines Exhaust Bypass - Disassemble
3606 and 3608 Engines Temperature Contactor