Turbocharger - Remove
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Remove tube assemblies (2), (3), (4), (5), (7), and (9).
- Disconnect tube assembly (8).
- Disconnect elbow (1).
- Remove nuts (6).
- Use a suitable lifting device in order to remove turbocharger (10). Remove turbocharger (10) and the gasket. The weight of turbocharger (10) is approximately
41 kg (90 lb) .
Show/hide table
| |
| Illustration 1 | g01082453 |
Caterpillar Information System:
3054 Truck Engine Engine Crankcase Breather - Clean
G3408 and G3412 Engines Connecting Rod
3412E and C30 Engines Front Power Take-Off (FPTO)
3612 and 3616 Engines Probe Adapter
3612 and 3616 Engines Probe Adapter
3612 and 3616 Engines Temperature Sensor
3612 and 3616 Engines Air Inlet Elbow
3408E and 3412E Engines for Caterpillar Built Machines Injection Actuation Pressure Sensor - Remove and Install
3412E, C30 and C32 Marine Engines Atmospheric Pressure Sensor - Remove and Install
3412E, C30 and C32 Marine Engines Engine Oil Temperature Sensor - Remove and Install
3412E, C30 and C32 Marine Engines Fuel Temperature Sensor - Remove and Install
3412E, C30 and C32 Marine Engines Fuel Pressure Sensor - Remove and Install
3054 Truck Engine Idle RPM - Check/Adjust
Installation Of The 170-3519 Timing Calibration Harness Assembly {1900, 1905} Installation Of The 170-3519 Timing Calibration Harness Assembly {1900, 1905}
3412E and C30 Marine Engines Model View Illustrations
G3408 and G3412 Engines Piston and Rings - Gallery Piston
3606 and 3608 Engines Pressure Contactor
3304B and 3306B Engines for Caterpillar Built Machines Spacer Plate - Remove and Install
3054 Engine for Caterpillar Built Machines V-Belts - Remove and Install
3612 and 3616 Engines Engine Speed Sensor
3606 and 3608 Engines Temperature Contactor
G3606 and G3608 Engines Fuel Control Valve - Remove and Install
3054 Engine for Caterpillar Built Machines Camshaft Gear - Remove and Install
3606 and 3608 Engines Temperature Contactor