Usage:
65E (1GM, 6GS),
75E (1HM, 6HS),
85E (1NM, 6JS),
95E (1SM, 6KS) Agricultural Tractors Powered by 3176C and 3196C Machine Engines
Reference: RENR1217-02; Specifications, 3176 & 3196 Engine For Caterpillar Built Machines 6AR, 7ZR.
The following information was omitted from the Reference Specification module. Please make note of this information in the Reference Specification. This information will be added to the next revision of RENR1217-02.
When the electric starting motor is viewed from the drive end, the motor rotates in the following direction ... Clockwise
No load conditions at 25°C (77°F) Speed ... 6900 ± 1800 rpm
Current draw ... 150.5 ± 27.5 amp Voltage ... 11V
(1) Battery terminal
A maximum of three cables or wire terminals should be between the nuts.
Tighten the nut on the battery terminal to the following torque ... 30.5 ± 3.5 N·m (22 ± 3 lb ft)
(2) Ground terminal
Tighten the nut on the ground terminal to the following torque ... 30.5 ± 3.5 N·m (22 ± 3 lb ft)
(3) Ground terminal
Tighten the nut on the ground terminal to the following torque ... 2.25 ± 0.25 N·m (20 ± 2 lb in)
(4) Switch terminal
Tighten the nut on the switch terminal to the following torque ... 2.25 ± 0.25 N·m (20 ± 2 lb in)
(5) Motor terminal
Tighten the nut on the motor terminal to the following torque ... 30.5 ± 3.5 N·m (20 ± 32 lb ft)
(6) Motor frame terminal
Tighten the nut on the motor frame terminal to the following torque ... 8 ± 3 N·m (72 ± 24 lb in)
Clearance between the pinion and the housing ... 9.1 mm (.36 in)
Solenoid
Current draw at 10V 25°C (77°F)
Pull-in windings ... 97 Amp
Hold-in windings ... 18 Amp maximum