Flywheel - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 439-3938 | Lifting Bracket | 2 |
B | - | Guide Stud 5/8 - 18 by 8 inch |
2 |
C | - | Loctite Moly Paste | - |
- Install Tooling (A) and a suitable lifting device on flywheel (2). The weight of flywheel (2) is approximately
44 kg (97 lb) . - Remove two bolts (1). Install Tooling (B).
- Remove remaining bolts (1). Remove flywheel (2).
Show/hide table
Illustration 2 g01091705 - Use a hammer and a punch to remove ring gear (3) from flywheel (2).
Show/hide table
Illustration 1 | g01091639 |
- Install flywheel (2) in the reverse order of removal.
- Raise the temperature of ring gear (3) and install onto flywheel (2).
- Apply Tooling (C) to the treads of bolts (1).
- Tighten bolts (1), in a star pattern, to a torque of
100 ± 5 N·m (74 ± 4 lb ft) . Tighten , in a star pattern, an extra 90°± 5°.
Caterpillar Information System:
3512C and 3516C Marine Engines Electronic Control Module (ECM)
C18 Marine Engines Engine Support (Front) - Remove and Install
C7.1-XQ200 Rental Generator Set Belts - Inspect/Adjust/Replace
C18 Marine Engines Engine Oil Pump - Remove and Install
G3500 Engines Product Lifting
320E and 323E Excavators Engine and Machine Warm-Up
2012/05/23 New Cylinder Head Gasket on Certain 3044C and C3.4 Engines {1100, 1100, 7555}
3516B Engine for the MT4400D Off-Highway Truck Fuel Injection Lines
3516B Engine for the MT4400D Off-Highway Truck Flywheel Housing Cover
3516B Engine for the MT4400D Off-Highway Truck Engine Oil Filter
G3500 Generator Sets Fuel Filter Differential Pressure - Check
3512C and 3516C Marine Propulsion Engines Synchronization Problem
C18 Marine Engines Crankshaft Rear Seal - Remove and Install
C18 Marine Engines Flywheel Housing - Remove and Install
C18 Marine Engines Vibration Damper and Pulley - Remove and Install
C18 Marine Engines Crankshaft Front Seal - Remove and Install
C18 Marine Engines Front Cover - Remove and Install
Installation Instruction of Firmware on Network Management Cards{4480, 7620} Installation Instruction of Firmware on Network Management Cards{4480, 7620}
C18 Marine Engines Gear Group (Front) - Remove and Install
C18 Marine Engines Housing (Front) - Remove and Install
G3516C and G3516E Gas Engines Engine Oil Cooler Bypass Valve
3516B Engine for the MT4400D Off-Highway Truck Air Lines - Aftercooler
C7.1 Industrial Engine Air Inlet and Exhaust System - Series Turbochargers
C7.1 Industrial Engine Turbocharger - Inspect - Series Turbochargers