Product Lifting
Show/hide table
| |
| 图 1 | g00103219 |
Show/hide table
| 注意 |
|---|
|
千万不要折弯吊环螺栓和支架。 吊环螺栓和支架只能承受张力负荷。 要记住当支承构件和物体之间的角度小于90°时，吊环螺栓的承载能力变小。 当必须在某一角度搬移部件时，只能使用具有适当额定载荷的连杆支架。 |
使用起重机搬移重的部件。 使用一个可调的吊粱起吊发动机。 所有的支承构件（链条和钢丝绳）应互相平行。 链条和钢丝绳与被吊物的顶面尽可能保持垂直。
有些搬移工作要求用吊装工具吊装，以确保平衡和安全。
吊耳是为特定的发动机装置设计和安装的。 更换吊耳和/或发动机会使吊耳和吊具不能使用。 如果更换了吊环螺栓和/或发动机，则应确保提供合适的起吊装置。 有关正确起吊发动机的吊具资料，请向 Cat 代理商咨询。
Show/hide table
| |
| 图 2 | g03048296 |
|
拆下零件以获得良好视野。 | |
Show/hide table
| |
| 图 3 | g03048297 |
Show/hide table
| |
| 图 4 | g03048299 |
Caterpillar Information System:
320E and 323E Excavators Engine and Machine Warm-Up
2012/05/23 New Cylinder Head Gasket on Certain 3044C and C3.4 Engines {1100, 1100, 7555}
3516B Engine for the MT4400D Off-Highway Truck Fuel Injection Lines
3516B Engine for the MT4400D Off-Highway Truck Flywheel Housing Cover
3516B Engine for the MT4400D Off-Highway Truck Engine Oil Filter
G3500 Generator Sets Fuel Filter Differential Pressure - Check
3512C and 3516C Marine Propulsion Engines Synchronization Problem
G3500 Generator Sets Engine Air Cleaner Element (Single Element) - Inspect/Replace
3516B Engine for the MT4400D Off-Highway Truck Water Lines
3516B Engine for the MT4400D Off-Highway Truck Water Lines
G3500 Generator Sets Coolant Temperature Regulator - Replace
G3516C and G3516E Gas Engines Water Lines
C18 Marine Engines Engine Oil Pump - Remove and Install
C7.1-XQ200 Rental Generator Set Belts - Inspect/Adjust/Replace
C18 Marine Engines Engine Support (Front) - Remove and Install
3512C and 3516C Marine Engines Electronic Control Module (ECM)
C18 Marine Engines Flywheel - Remove and Install
C18 Marine Engines Crankshaft Rear Seal - Remove and Install
C18 Marine Engines Flywheel Housing - Remove and Install
C18 Marine Engines Vibration Damper and Pulley - Remove and Install
C18 Marine Engines Crankshaft Front Seal - Remove and Install
C18 Marine Engines Front Cover - Remove and Install
Installation Instruction of Firmware on Network Management Cards{4480, 7620} Installation Instruction of Firmware on Network Management Cards{4480, 7620}
C18 Marine Engines Gear Group (Front) - Remove and Install