Engine Oil Pump - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | - | Loctite 587 | - |
Start By:
- Remove the engine oil pan.
- Remove tube assembly (3). Remove suction bell (1) and remove tube assembly (2). Discard the O-ring seals from tube assemblies (3) and (2).
- Remove engine oil pump (4).
- Remove plate (5) and discard gasket (6).
Show/hide table
Illustration 1 | g03049437 |
- Install engine oil pump (4) in the reverse order of removal.
- Apply a bead of Tooling (A) to Area (X). the bead should have a constant cross section constant of
3 to 5 mm (0.12 to 0.20 inch) . Install gasket (6) within 10 minutes of applying Tooling (A). - Lubricate the O-ring seals and bores for tube assemblies (3) and (2) with clean engine oil.
Show/hide tableIllustration 2 g03049540 - Apply a bead of Tooling (A) to Area (X). the bead should have a constant cross section constant of
Caterpillar Information System:
G3500 Engines Product Lifting
320E and 323E Excavators Engine and Machine Warm-Up
2012/05/23 New Cylinder Head Gasket on Certain 3044C and C3.4 Engines {1100, 1100, 7555}
3516B Engine for the MT4400D Off-Highway Truck Fuel Injection Lines
3516B Engine for the MT4400D Off-Highway Truck Flywheel Housing Cover
3516B Engine for the MT4400D Off-Highway Truck Engine Oil Filter
G3500 Generator Sets Fuel Filter Differential Pressure - Check
3512C and 3516C Marine Propulsion Engines Synchronization Problem
G3500 Generator Sets Engine Air Cleaner Element (Single Element) - Inspect/Replace
3516B Engine for the MT4400D Off-Highway Truck Water Lines
3516B Engine for the MT4400D Off-Highway Truck Water Lines
G3500 Generator Sets Coolant Temperature Regulator - Replace
C7.1-XQ200 Rental Generator Set Belts - Inspect/Adjust/Replace
C18 Marine Engines Engine Support (Front) - Remove and Install
3512C and 3516C Marine Engines Electronic Control Module (ECM)
C18 Marine Engines Flywheel - Remove and Install
C18 Marine Engines Crankshaft Rear Seal - Remove and Install
C18 Marine Engines Flywheel Housing - Remove and Install
C18 Marine Engines Vibration Damper and Pulley - Remove and Install
C18 Marine Engines Crankshaft Front Seal - Remove and Install
C18 Marine Engines Front Cover - Remove and Install
Installation Instruction of Firmware on Network Management Cards{4480, 7620} Installation Instruction of Firmware on Network Management Cards{4480, 7620}
C18 Marine Engines Gear Group (Front) - Remove and Install
C18 Marine Engines Housing (Front) - Remove and Install