Front Cover - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | - | LOCTITE 263 | - |
- | LOCTITE 270(1) | - |
Show/hide table
(1) | Europe Only |
Start By:
- Remove fuel filter base.
- Remove fuel filter mounting bracket (1).
Show/hide table
Illustration 2 g03050596 - Remove head screws (3). Remove locknuts (4) and spacers (5).
- Remove studs (6) and discard the O-ring seals. Use new O-ring seals for installation.
- Remove front cover (2).
Show/hide table
Illustration 1 | g03050557 |
- Install front cover (2) in the reverse order of removal.
- Install new O-ring seals and apply Tooling (A) to the threads of studs (6).
Note: The threads that are threaded into the front housing receives Tooling (A).
- Tighten head screws (3) to a torque of
21 ± 3 N·m (186 ± 27 lb in) .
- Install new O-ring seals and apply Tooling (A) to the threads of studs (6).
Caterpillar Information System:
C18 Marine Engines Crankshaft Front Seal - Remove and Install
C18 Marine Engines Vibration Damper and Pulley - Remove and Install
C18 Marine Engines Flywheel Housing - Remove and Install
C18 Marine Engines Crankshaft Rear Seal - Remove and Install
C18 Marine Engines Flywheel - Remove and Install
3512C and 3516C Marine Engines Electronic Control Module (ECM)
C18 Marine Engines Engine Support (Front) - Remove and Install
C7.1-XQ200 Rental Generator Set Belts - Inspect/Adjust/Replace
C18 Marine Engines Engine Oil Pump - Remove and Install
G3500 Engines Product Lifting
320E and 323E Excavators Engine and Machine Warm-Up
2012/05/23 New Cylinder Head Gasket on Certain 3044C and C3.4 Engines {1100, 1100, 7555}
Installation Instruction of Firmware on Network Management Cards{4480, 7620} Installation Instruction of Firmware on Network Management Cards{4480, 7620}
C18 Marine Engines Gear Group (Front) - Remove and Install
C18 Marine Engines Housing (Front) - Remove and Install
G3516C and G3516E Gas Engines Engine Oil Cooler Bypass Valve
3516B Engine for the MT4400D Off-Highway Truck Air Lines - Aftercooler
C7.1 Industrial Engine Air Inlet and Exhaust System - Series Turbochargers
C7.1 Industrial Engine Turbocharger - Inspect - Series Turbochargers
2012/09/13 A New Turbocharger Housing is Used on Certain 3512 Engines {1052, 1065}
C7.1 Industrial Engine Turbocharger - Inspect - Single Turbocharger
C7.1 Industrial Engine Air Inlet and Exhaust System - Single Turbocharger
C7.1 Industrial Engine Fuel Injection
3500B Generator Sets Generator Bearing Temperature - Test/Record