Vibration Damper and Pulley - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 4C-5592 | Anti-Seize Compound | - |
185-3989(1) | Thread Lubricant | - |
Show/hide table
(1) | For use in EAME |
- Remove belt (1) from pulley (2). Refer to Operation and Maintenance Manual, "Alternator Belt - Inspect/Adjust/Replace".
- Remove nuts (3) and pulley (2).
- Slide vibration damper (5) along studs (4). Attach a suitable lifting device to vibration damper (5). The weight of vibration damper (5) is approximately
50 kg (110 lb) . Remove vibration damper (5) from studs (4). - Remove studs (4), if necessary.
- Attach a suitable lifting device to damper adapter (6), if necessary. The weight of damper adapter (6) is approximately
23 kg (50 lb) . Remove bolts (7) and damper adapter (6).
Show/hide table
Illustration 1 | g03119478 |
Show/hide table
NOTICE |
---|
Thoroughly inspect the viscous damper for signs of leakage or for signs of a dented (damaged) case. Either of these conditions can cause the weight to make contact with the case. This can affect the viscous damper's operation. |
- Install vibration damper (5) in the reverse order of removal.
- Apply Tooling (A) to bolts (7).
- Tighten studs (4) to a torque of
65 ± 10 N·m (48 ± 7 lb ft) . - Tighten nuts (3) to a torque of
135 ± 20 N·m (100 ± 15 lb ft) .
Caterpillar Information System:
C18 Marine Engines Flywheel Housing - Remove and Install
C18 Marine Engines Crankshaft Rear Seal - Remove and Install
C18 Marine Engines Flywheel - Remove and Install
3512C and 3516C Marine Engines Electronic Control Module (ECM)
C18 Marine Engines Engine Support (Front) - Remove and Install
C7.1-XQ200 Rental Generator Set Belts - Inspect/Adjust/Replace
C18 Marine Engines Engine Oil Pump - Remove and Install
G3500 Engines Product Lifting
320E and 323E Excavators Engine and Machine Warm-Up
2012/05/23 New Cylinder Head Gasket on Certain 3044C and C3.4 Engines {1100, 1100, 7555}
3516B Engine for the MT4400D Off-Highway Truck Fuel Injection Lines
3516B Engine for the MT4400D Off-Highway Truck Flywheel Housing Cover
C18 Marine Engines Crankshaft Front Seal - Remove and Install
C18 Marine Engines Front Cover - Remove and Install
Installation Instruction of Firmware on Network Management Cards{4480, 7620} Installation Instruction of Firmware on Network Management Cards{4480, 7620}
C18 Marine Engines Gear Group (Front) - Remove and Install
C18 Marine Engines Housing (Front) - Remove and Install
G3516C and G3516E Gas Engines Engine Oil Cooler Bypass Valve
3516B Engine for the MT4400D Off-Highway Truck Air Lines - Aftercooler
C7.1 Industrial Engine Air Inlet and Exhaust System - Series Turbochargers
C7.1 Industrial Engine Turbocharger - Inspect - Series Turbochargers
2012/09/13 A New Turbocharger Housing is Used on Certain 3512 Engines {1052, 1065}
C7.1 Industrial Engine Turbocharger - Inspect - Single Turbocharger
C7.1 Industrial Engine Air Inlet and Exhaust System - Single Turbocharger