Housing (Front) - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | - | Loctite 587 | - |
Start By:
- Remove the engine oil filter base.
- Remove the camshaft gear.
- Remove the crankshaft front seal.
- Remove the camshaft position sensor.
- Remove the crankshaft position sensor.
- Remove the alternator.
- Remove the water pump.
- Remove the auxiliary water pumps.
- Remove the front engine support.
Show/hide table
NOTICE |
---|
Do not turn the crankshaft or the camshaft while the camshaft gear is removed. If the front gear group is not correctly timed during installation, interference can occur between the pistons and the valves, resulting in damage to the engine. |
- Remove bolts (1).
- Remove bolts (2) and bracket (3).
- Remove nut (4).
- Remove bolts (5) and bolts (6).
- Remove bolts (7).
Show/hide table
Illustration 2 g01366132 - Remove the bolts and strap (8).
- Remove studs (10) and nut (9).
- Remove bolts (11).
- Remove front housing (12).
- Discard the gasket from the plate and front housing (12). Use a new gasket for installation.
Show/hide table
Illustration 1 | g01366101 |
- Install front housing (12) in the reverse order of removal.
- Trim the gasket even with the bottom of front housing (12) after assembly.
- Apply Tooling (A) to the bottom of the gasket to fill the space at front housing (12) and the engine oil pan.
Note: The mating surfaces of the plate and the front housing must be free of oil, fuel, water, dirt, assembly compounds, and any other contaminants.
Caterpillar Information System:
C18 Marine Engines Gear Group (Front) - Remove and Install
Installation Instruction of Firmware on Network Management Cards{4480, 7620} Installation Instruction of Firmware on Network Management Cards{4480, 7620}
C18 Marine Engines Front Cover - Remove and Install
C18 Marine Engines Crankshaft Front Seal - Remove and Install
C18 Marine Engines Vibration Damper and Pulley - Remove and Install
C18 Marine Engines Flywheel Housing - Remove and Install
C18 Marine Engines Crankshaft Rear Seal - Remove and Install
C18 Marine Engines Flywheel - Remove and Install
3512C and 3516C Marine Engines Electronic Control Module (ECM)
C18 Marine Engines Engine Support (Front) - Remove and Install
C7.1-XQ200 Rental Generator Set Belts - Inspect/Adjust/Replace
C18 Marine Engines Engine Oil Pump - Remove and Install
G3516C and G3516E Gas Engines Engine Oil Cooler Bypass Valve
3516B Engine for the MT4400D Off-Highway Truck Air Lines - Aftercooler
C7.1 Industrial Engine Air Inlet and Exhaust System - Series Turbochargers
C7.1 Industrial Engine Turbocharger - Inspect - Series Turbochargers
2012/09/13 A New Turbocharger Housing is Used on Certain 3512 Engines {1052, 1065}
C7.1 Industrial Engine Turbocharger - Inspect - Single Turbocharger
C7.1 Industrial Engine Air Inlet and Exhaust System - Single Turbocharger
C7.1 Industrial Engine Fuel Injection
3500B Generator Sets Generator Bearing Temperature - Test/Record
C18 Marine Engines Valve Mechanism Cover - Remove and Install
C7.1 Industrial Engine Electronic Control System
C7.1 Industrial Engine Power Sources