Belts - Inspect/Adjust/Replace
Show/hide table
NOTICE |
---|
Ensure that the engine is stopped before any servicing or repair is performed. |
To maximize the engine performance, inspect the belt (1) for wear and for cracking. Replace the belt if the belt is worn or damaged.
- If the belt (1) has more than four cracks per 25.4000 mm (1 inch), the belt must be replaced.
- Check the belt for the following items: cracks, splits, glazing, grease, splitting and broken ribs
- Remove any deposits that are on the belt.
Show/hide table
Illustration 1 | g03049697 |
Typical example |
Caterpillar Information System:
C18 Marine Engines Engine Oil Pump - Remove and Install
G3500 Engines Product Lifting
320E and 323E Excavators Engine and Machine Warm-Up
2012/05/23 New Cylinder Head Gasket on Certain 3044C and C3.4 Engines {1100, 1100, 7555}
3516B Engine for the MT4400D Off-Highway Truck Fuel Injection Lines
3516B Engine for the MT4400D Off-Highway Truck Flywheel Housing Cover
3516B Engine for the MT4400D Off-Highway Truck Engine Oil Filter
G3500 Generator Sets Fuel Filter Differential Pressure - Check
3512C and 3516C Marine Propulsion Engines Synchronization Problem
G3500 Generator Sets Engine Air Cleaner Element (Single Element) - Inspect/Replace
3516B Engine for the MT4400D Off-Highway Truck Water Lines
3516B Engine for the MT4400D Off-Highway Truck Water Lines
C18 Marine Engines Engine Support (Front) - Remove and Install
3512C and 3516C Marine Engines Electronic Control Module (ECM)
C18 Marine Engines Flywheel - Remove and Install
C18 Marine Engines Crankshaft Rear Seal - Remove and Install
C18 Marine Engines Flywheel Housing - Remove and Install
C18 Marine Engines Vibration Damper and Pulley - Remove and Install
C18 Marine Engines Crankshaft Front Seal - Remove and Install
C18 Marine Engines Front Cover - Remove and Install
Installation Instruction of Firmware on Network Management Cards{4480, 7620} Installation Instruction of Firmware on Network Management Cards{4480, 7620}
C18 Marine Engines Gear Group (Front) - Remove and Install
C18 Marine Engines Housing (Front) - Remove and Install
G3516C and G3516E Gas Engines Engine Oil Cooler Bypass Valve