Camshaft - Install
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 201-4211 | Camshaft Pilot | 1 |
201-4212 | Camshaft Pilot | 1 |
- Install Tooling (A).
Note: Ensure that camshaft (2) and Tooling (A) are clean. Apply clean engine oil to the lobes and journals of camshaft (2) and Tooling (A).
Note: During installation of camshaft (2), rotate the camshaft in both directions in order to prevent binding in the camshaft bearing bores.
- Carefully install camshaft (2) in the engine.
Show/hide table
NOTICE When installing the camshaft, make sure the number one cylinder is at top center of the compression stroke with the timing bolt installed in the flywheel. The camshaft timing is very important. The timing mark on the camshaft drive gear must line up with the timing mark on the idler gear. Refer to the Specifications Manual for more information.
Show/hide tableIllustration 2 g00813917 - Ensure that the timing marks (3) on the idler gear are aligned with the timing marks on the crankshaft gear and the camshaft drive gear.
Show/hide table
Illustration 3 g01011039 - Install bolts (1). Remove the wires that were used to hold the valve lifters.
Show/hide table
Illustration 1 | g01011042 |
End By:
- Install the camshaft position sensor. Refer to Disassembly and Assembly, "Camshaft Position Sensor - Remove and Install".
- Install the front cover. Refer to Disassembly and Assembly, "Front Cover - Install".
- Install the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install".
Caterpillar Information System:
C13 Engine Camshaft - Remove
Inspection of Slag Buckets{6110} Inspection of Slag Buckets{6110}
C13 Engine Lifter Group - Remove and Install
C13 Engine Cylinder Head - Install
C13 Engine Cylinder Head - Remove
C13 Engine Rocker Shaft and Pushrod - Install
C13 Engine Rocker Shaft - Assemble
C13 Engine Rocker Shaft - Disassemble
C13 Engine Rocker Shaft and Pushrod - Remove
C13 Engine Valve Actuator (Variable) - Install
C13 Engine Valve Actuator (Variable) - Remove
C13 Engine Valve Mechanism Cover Base - Remove and Install
C13 Engine Camshaft Bearings - Remove
C13 Engine Camshaft Bearings - Install
C13 Engine Engine Oil Pan - Remove and Install
C13 Engine Cylinder Liner - Remove
C13 Engine Cylinder Liner - Install
C13 Engine Piston Cooling Jets - Remove and Install
C13 Engine Pistons and Connecting Rods - Remove
C13 Engine Pistons and Connecting Rods - Disassemble
C13 Engine Pistons and Connecting Rods - Assemble
C13 Engine Pistons and Connecting Rods - Install
C13 Engine Connecting Rod Bearings - Remove
C13 Engine Connecting Rod Bearings - Install