Pistons and Connecting Rods - Disassemble
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 4C-3601 | Piston Ring Expander | 1 |
B | 5P-8639 | Hydraulic Press | 1 |
8F-0024 | Hose Assembly | 1 | |
1P-2375 | Connecting Coupler | 1 | |
1P-2376 | Connecting Coupler | 1 | |
5P-9725 | Hydraulic Cylinder | 1 | |
5P-8651 | Spacer | 1 | |
5P-8649 | Adapter | 1 | |
5P-8650 | Adapter | 1 |
Start By:
- Remove the pistons and the connecting rods. Refer to Disassembly and Assembly, "Pistons and Connecting Rods - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (A) in order to remove piston rings (1) from piston (2).
- Remove retaining ring (3).
Note: Careful handling is required for fractured connecting rods. Fractured faces for the connecting rod and connecting rod cap should not be placed on any surface. The connecting rod and the connecting rod cap should be placed on the sides in order to prevent damage. When possible, the connecting rod and the connecting rod cap should be bolted together in order to prevent damage.
- Remove piston pin (6) and piston (2) from connecting rod (5).
Show/hide table
NOTICE The connecting rod must be heated for the installation of the piston pin bearing. Do not use a torch.
- Raise the temperature of connecting rod (5) in the indicated Area (X). The maximum distance of Area (X) is
85.0 mm (3.35 inch) . - Use Tooling (B) in order to remove old bearing (4) and install new bearing (4) at the same time. Refer to Specifications, "Connecting Rod".
Show/hide table
Illustration 1 | g01319591 |
Show/hide table
Illustration 2 | g01142147 |
Caterpillar Information System:
C13 Engine Pistons and Connecting Rods - Remove
C13 Engine Piston Cooling Jets - Remove and Install
C13 Engine Cylinder Liner - Install
C13 Engine Cylinder Liner - Remove
C13 Engine Engine Oil Pan - Remove and Install
C13 Engine Camshaft Bearings - Install
C13 Engine Camshaft Bearings - Remove
C13 Engine Camshaft - Install
C13 Engine Camshaft - Remove
Inspection of Slag Buckets{6110} Inspection of Slag Buckets{6110}
C13 Engine Lifter Group - Remove and Install
C13 Engine Cylinder Head - Install
C13 Engine Pistons and Connecting Rods - Assemble
C13 Engine Pistons and Connecting Rods - Install
C13 Engine Connecting Rod Bearings - Remove
C13 Engine Connecting Rod Bearings - Install
C13 Engine Crankshaft Main Bearings - Remove
C13 Engine Crankshaft Main Bearings - Install
C13 Engine Crankshaft - Remove
C13 Engine Crankshaft - Install
C13 Engine Crankshaft Gear - Remove and Install
C13 Engine Engine Sensors - Remove and Install
C13 Engine Fan Drive Mounting Group - Remove and Install
C13 Engine Engine Control Module - Remove and Install