Engine Oil Pan - Remove and Install
Removal Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | -     | Loctite 596     | 1     |
- Drain the oil into a suitable container. Refer to Operation and Maintenance Manual, "Refill Capacities and Recommendations".
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Remove bolts (1), washers (2), fastener assemblies (3) and remove oil pan (4) .
Show/hide table
Illustration 1 | g02466033 |
Installation Procedure
- Apply Tooling (A) at four locations marked (A). Tooling (A) should be applied in 4 ± 1 mm (0.16 ± 0.04 inch) diameter beads.
Note: All joints using Tooling (A) must be assembled within ten minutes of the application.
Show/hide table
Illustration 2 | g02466177 |
Note: Ensure that the oil pan and mating surfaces are clean and free of oil.
- Install fastener assemblies (3) and the gasket (not shown) onto oil pan (4) .
Show/hide table
Illustration 3 | g02466556 |
- Position oil pan (4), washers (2), and bolts (1) into place.
Show/hide table
Illustration 4 | g02466576 |
Show/hide table
Illustration 5 | g02466597 |
Torque Sequence |
- Tighten bolts (1) in the above sequence.
- Fill the engine with oil. Refer to Operation and Maintenance Manual, "Refill Capacities and Recommendations".
Caterpillar Information System:
C13 Engine Camshaft Bearings - Install
C13 Engine Camshaft Bearings - Remove
C13 Engine Camshaft - Install
C13 Engine Camshaft - Remove
Inspection of Slag Buckets{6110} Inspection of Slag Buckets{6110}
C13 Engine Lifter Group - Remove and Install
C13 Engine Cylinder Head - Install
C13 Engine Cylinder Head - Remove
C13 Engine Rocker Shaft and Pushrod - Install
C13 Engine Rocker Shaft - Assemble
C13 Engine Rocker Shaft - Disassemble
C13 Engine Rocker Shaft and Pushrod - Remove
C13 Engine Cylinder Liner - Remove
C13 Engine Cylinder Liner - Install
C13 Engine Piston Cooling Jets - Remove and Install
C13 Engine Pistons and Connecting Rods - Remove
C13 Engine Pistons and Connecting Rods - Disassemble
C13 Engine Pistons and Connecting Rods - Assemble
C13 Engine Pistons and Connecting Rods - Install
C13 Engine Connecting Rod Bearings - Remove
C13 Engine Connecting Rod Bearings - Install
C13 Engine Crankshaft Main Bearings - Remove
C13 Engine Crankshaft Main Bearings - Install
C13 Engine Crankshaft - Remove