Cylinder Head - Remove
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 138-7575 | Link Bracket | 2 |
Start By:
- Remove the fan drive mounting group. Refer to Disassembly and Assembly, "Fan Drive Mounting Group - Remove and Install".
- Remove the valve mechanism cover base. Refer to Disassembly and Assembly, "Valve Mechanism Cover Base - Remove and Install".
- Remove the turbochargers. Refer to Disassembly and Assembly, "Turbocharger - Remove".
- Remove the electronic unit injectors. Refer to Disassembly and Assembly, "Electronic Unit Injector - Remove".
- Remove the precooler. Refer to Disassembly and Assembly, "Precooler - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Remove air tube assembly (1). Disconnect hose assembly (2). Cut all cable straps that connect harness assembly (3) to the cylinder head. Move harness assembly aside.
Show/hide table
Illustration 2 g01018267 - Disconnect hose assemblies (5) and (6). Disconnect clamp (4) from the cylinder head. Remove bolts (7).
Show/hide table
Illustration 3 g01018269 - Disconnect the following items: clip (8), wire assembly (10) and harness assembly from sensor (12). Disconnect hose assembly (9) from the cylinder head. Remove bolt (11).
Show/hide table
Illustration 4 g01018271 - Disconnect harness assembly (14).
Show/hide table
Illustration 5 g01018505 - Remove cylinder head bolts (19).
- Attach Tooling (A) and a suitable lifting device to the cylinder head. Carefully remove the cylinder head from the cylinder block. The weight of the cylinder head is approximately
184 kg (405 lb) .
Show/hide table
Illustration 1 | g01018266 |
Caterpillar Information System:
C13 Engine Rocker Shaft and Pushrod - Install
C13 Engine Rocker Shaft - Assemble
C13 Engine Rocker Shaft - Disassemble
C13 Engine Rocker Shaft and Pushrod - Remove
C13 Engine Valve Actuator (Variable) - Install
C13 Engine Valve Actuator (Variable) - Remove
C13 Engine Valve Mechanism Cover Base - Remove and Install
C13 Engine Valve Mechanism Cover - Remove and Install
C13 Engine Accessory Drive - Install
C13 Engine Accessory Drive - Remove
2009/04/20 An Improved Exhaust Bellows Assembly Is Used on 3500HD Locomotive Engines {1052, 1053}
789D, 793F, and 797F Off-Highway Truck Monitoring System Charging System
C13 Engine Cylinder Head - Install
C13 Engine Lifter Group - Remove and Install
Inspection of Slag Buckets{6110} Inspection of Slag Buckets{6110}
C13 Engine Camshaft - Remove
C13 Engine Camshaft - Install
C13 Engine Camshaft Bearings - Remove
C13 Engine Camshaft Bearings - Install
C13 Engine Engine Oil Pan - Remove and Install
C13 Engine Cylinder Liner - Remove
C13 Engine Cylinder Liner - Install
C13 Engine Piston Cooling Jets - Remove and Install
C13 Engine Pistons and Connecting Rods - Remove