Piston Cooling Jets - Remove and Install
Start By:
- Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Show/hide table
| NOTICE |
|---|
|
Special care must be taken not to bend the piston cooling jets because the piston cooling jets are precision aligned with a coolant passage in the pistons. There is only one position for each cooling jet. The notch in the bottom of the piston allows clearance for the piston cooling jet when the piston is at bottom dead center. |
- Remove bolt (1) and piston cooling jet (2).
Show/hide table
| |
| Illustration 1 | g01133547 |
Show/hide table
| NOTICE |
|---|
|
Special care must be taken not to bend the piston cooling jets because the piston cooling jets are precision aligned with a coolant passage in the pistons. There is only one position for each cooling jet. The notch in the bottom of the piston allows clearance for the piston cooling jet when the piston is at bottom dead center. |
- Position piston cooling jet (2) and install bolt (1). Tighten bolt (1) to a torque of
35 ± 3 N·m (26 ± 2 lb ft) .
Show/hide table
|
| |
| Illustration 2 | g01133547 |
End By:
- Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Caterpillar Information System:
C13 Engine Cylinder Liner - Install
C13 Engine Cylinder Liner - Remove
C13 Engine Engine Oil Pan - Remove and Install
C13 Engine Camshaft Bearings - Install
C13 Engine Camshaft Bearings - Remove
C13 Engine Camshaft - Install
C13 Engine Camshaft - Remove
Inspection of Slag Buckets{6110} Inspection of Slag Buckets{6110}
C13 Engine Lifter Group - Remove and Install
C13 Engine Cylinder Head - Install
C13 Engine Cylinder Head - Remove
C13 Engine Rocker Shaft and Pushrod - Install
C13 Engine Pistons and Connecting Rods - Remove
C13 Engine Pistons and Connecting Rods - Disassemble
C13 Engine Pistons and Connecting Rods - Assemble
C13 Engine Pistons and Connecting Rods - Install
C13 Engine Connecting Rod Bearings - Remove
C13 Engine Connecting Rod Bearings - Install
C13 Engine Crankshaft Main Bearings - Remove
C13 Engine Crankshaft Main Bearings - Install
C13 Engine Crankshaft - Remove
C13 Engine Crankshaft - Install
C13 Engine Crankshaft Gear - Remove and Install
C13 Engine Engine Sensors - Remove and Install