Camshaft Bearings - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 201-4214 | Receiving Sleeve | 1 |
201-4213 | Puller Plate | 1 | |
201-4209 | Bearing Pilot | 1 | |
201-4208 | Backup Plate | 1 | |
6F-7032 | Bolt | 1 | |
8M-8778 | Taperlock Stud | 1 | |
8S-8292 | Extension (Short) | 2 | |
8S-8293 | Extension (Long) | 1 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g01133376 |
- Position new camshaft bearing (1) in Tooling (A) and install the bearing from the rear to the front of the engine.
Show/hide table
Illustration 2 g01133395 - The camshaft bearings are installed with Tooling (A). Measure the depth of the camshaft bearings from the front face of the cylinder block to the following distances:
- Dimension (A) is
36.50 mm (1.437 inch) . - Dimension (B) is
192.50 mm (7.579 inch) . - Dimension (C) is
348.50 mm (13.720 inch) . - Dimension (D) is
504.50 mm (19.862 inch) . - Dimension (E) is
660.50 mm (26.004 inch) . - Dimension (F) is
816.50 mm (32.146 inch) . - Dimension (G) is
972.50 mm (38.287 inch) .
- Dimension (A) is
Show/hide table
NOTICE |
---|
Camshaft bearings must be installed into their correct position. Failure to do so will result in engine damage. |
Show/hide table
Illustration 3 | g01133403 |
(2) Bearing joint
(3) Oil hole
(H) Bearing oil hole is located at a 45 degree angle from vertical. All seven bearings have the same angle.
End By:
- Install the camshaft. Refer to Disassembly and Assembly, "Camshaft - Install".
- Install the lifter group. Refer to Disassembly and Assembly, "Lifter Group - Remove and Install".
Caterpillar Information System:
C13 Engine Camshaft Bearings - Remove
C13 Engine Camshaft - Install
C13 Engine Camshaft - Remove
Inspection of Slag Buckets{6110} Inspection of Slag Buckets{6110}
C13 Engine Lifter Group - Remove and Install
C13 Engine Cylinder Head - Install
C13 Engine Cylinder Head - Remove
C13 Engine Rocker Shaft and Pushrod - Install
C13 Engine Rocker Shaft - Assemble
C13 Engine Rocker Shaft - Disassemble
C13 Engine Rocker Shaft and Pushrod - Remove
C13 Engine Valve Actuator (Variable) - Install
C13 Engine Engine Oil Pan - Remove and Install
C13 Engine Cylinder Liner - Remove
C13 Engine Cylinder Liner - Install
C13 Engine Piston Cooling Jets - Remove and Install
C13 Engine Pistons and Connecting Rods - Remove
C13 Engine Pistons and Connecting Rods - Disassemble
C13 Engine Pistons and Connecting Rods - Assemble
C13 Engine Pistons and Connecting Rods - Install
C13 Engine Connecting Rod Bearings - Remove
C13 Engine Connecting Rod Bearings - Install
C13 Engine Crankshaft Main Bearings - Remove
C13 Engine Crankshaft Main Bearings - Install