Oil Cooler (Engine) - Remove and Install
Start By:
- Remove the engine oil filter.
- Remove the electronic control module (ECM).
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Show/hide table
Illustration 1 g06386832 - Remove the cable straps and disconnect harness assemblies (1) and (2).
Show/hide table
Illustration 2 g06386835 - Remove bolts (3) and bracket assembly (4).
Show/hide table
Illustration 3 g06387019 - Remove four bolts (6) and three bolts (7). Remove oil filter base (5) and the gasket.
- Remove remaining bolts (7). Remove engine oil cooler (8) and the gasket.
- Install engine oil cooler (8) in the reverse order of removal.
- Tighten bolts (7) in the sequence as shown in illustration 4. Tighten bolts (7) to a torque of
22 N·m (195 lb in) .
Show/hide table
Illustration 4 g06386926 Typical Example - Tighten bolts (7) in the sequence as shown in illustration 4. Tighten bolts (7) to a torque of
Caterpillar Information System:
Exhaust Cooler (NRS) on Certain C7.1 and C6.6 Machine Engines {1061, 1087, 108C} Exhaust Cooler (NRS) on Certain C7.1 and C6.6 Machine Engines {1061, 1087, 108C}
D6 Track-Type Tractor Electrohydraulic Systems Diagnostic Trouble Codes
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Air Inlet and Exhaust System Operation
New Troubleshooting Procedure for the Low Steering Pilot Pressure Code Is Now Used for Certain 854K Wheel Dozers and 992K Wheel Loaders {0732, 4300, 4306, 5070, 5073} New Troubleshooting Procedure for the Low Steering Pilot Pressure Code Is Now Used for Certain 854K Wheel Dozers and 992K Wheel Loaders {0732, 4300, 4306, 5070, 5073}
MD6250 Rotary Drill Systems Rotary Head - Test and Adjust
MD6250 Rotary Drill Systems Travel System - Test and Adjust
MD6250 Rotary Drill Systems Mast - Test and Adjust
MD6250 Rotary Drill Systems Leveling System - Test and Adjust
D3-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Model View Illustrations
New Engine Software is Now Available for Certain Track-Type Tractor Engines {1902, 1920, 7610, 7620} New Engine Software is Now Available for Certain Track-Type Tractor Engines {1902, 1920, 7610, 7620}
D8T and D9T Track-Type Tractors ECM - Configure
PL61 Pipelayers Engine Supplement Engine Oil Filter and Base - Remove and Install
MD6250 Rotary Drill Systems Counterbalance Valve - Test and Adjust - Mast Raise
D3-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Caterpillar Approved Work Tools
Installation of Counterweight and Ground Level Service Center on Certain D11 Track-Type Tractors {1408, 7056, 7153} Installation of Counterweight and Ground Level Service Center on Certain D11 Track-Type Tractors {1408, 7056, 7153}
D3-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Drive Line Wear Sleeve - Inspect/Replace - MTL Only
D9R Track-Type Tractor Power Train Torque Divider - Disassemble
New Improved Grapple Bucket Pins for Small Wheel Loaders {6101} New Improved Grapple Bucket Pins for Small Wheel Loaders {6101}
C7.1 Engines SCR Catalyst Has Incorrect Inlet Temperature
D9T Track-Type Tractor Machine Systems Battery and Wiring Group
PL61 Pipelayers Engine Supplement Fuel Filter and Base - Remove and Install
D3-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Belts - Inspect/Adjust
374 Excavator Declaration of Conformity
D6 Track-Type Tractor Electrohydraulic Systems Event Codes