- Wheel Loader
- 950L (S/N: TNS1-535; LXX1-10514)
- 950M (S/N: ENE1-10424; LCR1-300)
- 962L (S/N: MTN1-340; SXS1-10255)
- 962M (S/N: LSE1-10249; RCL1-201)
- 950M (S/N: ENE1-10424; LCR1-300)
Description Of Change: Improved bracket assembly is now used on machines listed above. The new bracket is designed to provide more clearance and facilitate installation of a two piece clip that will hold the tube with better rigidity.
Adaptable To: The following changes are adaptable to machines within the listed serial numbers and are effective with all machines after the listed serial numbers.
Follow the procedure below to update the new bracket assembly and clips on machines listed above.
Rework Procedure
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility. |
Required Parts | |||
---|---|---|---|
Item | Qty | Part Number | Description |
1 | 1 | Bracket As | |
2 | 1 | Bolt | |
3 | 1 | Washer | |
4 | 1 | Clip | |
5 | 1 | Clip |
- Remove the existing clip (F) from the bracket (A) by removing bolt (B) and nut (C). Disassembly the bracket (A) by removing two bolts (D) and two nuts (E). Save the removed nut (C), bolts (D), and nuts (E). Discard all other removed parts.
Show/hide table
Illustration 2 g06347099 (1) 563-3694 Bracket As
(2)8T-4196 Bolt
(3)7X-7729 Washer
(4)9X-2646 Clip
(5)9X-2647 Clip
(C) Nut
(D) Bolt
(E) Nut - Install bracket assembly (1) using two bolts (D) and two washers (E) that were saved in previous step. Orient the bracket assembly (1) as shown in Illustration 2. Secure the tube by installing clip (4) and clip (5) by mounting on bracket assembly (1) using bolt (2), washer (3), and nut (C) that was saved in previous step.
Illustration 1 | g06347087 |
(A) Bracket As
(B) Bolt (C) Nut (D) Bolt (E) Nut (F) Clip |