D6 XE Track-Type Tractor Power Train Caterpillar

Removal Procedure

Start By:

1. Remove the rear bottom guard.

1. Drain the power train oil. Refer to Operation and Maintenance Manual, "Power Train System Oil and Screens - Change/Clean".
   Show/hide table

   Illustration 1	g06346518

2. Loosen the bolts and disconnect hose assembly (1).

3. Remove the bolts and disconnect hose assembly (2).

4. Disconnect hose assembly (3).
   Show/hide table

   Illustration 2	g06346558

5. Remove bolts (4) and manifold (5).

   Note: The hose assembly will remain attached to manifold (5).

   Show/hide table

   Illustration 3	g06346575

6. Remove bolts (6), lubrication distribution manifold (7), and plate (8).
   Show/hide table

   Illustration 4	g06346616

7. Remove O-ring seals (9) and O-ring seals (10) from plate (8).

8. Remove plate (8) from lubrication distribution manifold (7).
   Show/hide table

   Illustration 5	g06346621

9. Remove O-ring seals (11) and O-ring seals (12) from lubrication distribution manifold (7).
   Show/hide table

   Illustration 6	g06346629

10. Remove bolts (13) and cover (14) from lubrication distribution manifold (7).
    Show/hide table

    Illustration 7	g06346637

11. Use a suitable hammer and punch to remove relief valve (15) from lubrication distribution manifold (7).
    Show/hide table

    Illustration 8	g06346647

12. Remove plug assembly (16) from lubrication distribution manifold (7).
    Show/hide table

    Illustration 9	g06346654

13. Remove O-ring seal (17), backup ring (18), O-ring seal (19), backup ring (20), and O-ring seal (21) from plug assembly (16).

Installation Procedure

1. Install lubrication distribution manifold (7) in the reverse order of removal.

   1. Tighten plug assembly (16) to a maximum torque of 34 N·m (25 lb ft).