D6T Track-Type Tractors Information Display Caterpillar

Module - Flash Program

Usage:

D6 AG9

Flashing the Display

Equipment Required:

VIMS cable 457-6114 Cable As
Current version of Cat^® Electronic Technician (Cat ET)
A personal computer (PC) with an Ethernet port (Display can only be flashed with a direct Ethernet connection.)

Note: The VIMS cable 457-6114 Cable As goes from the CA3 to the 14-pin service port on the machine. An Ethernet cable is still required to connect from the personal computer to the VIMS cable. The cable has a RJ45 port to plug in the Ethernet cable from the personal computer.

Cat Electronic Technician (Cat ET) Set-up Instructions

Note: The display can only be flashed with a direct Ethernet connection. To flash, connect an Ethernet cable to the RJ45 port on the CA3 adapter harness. Connect the remaining end of the Ethernet cable to the LAN connection on the computer.

Connect to "WINFLASH" in ET.
Show/hide table

Illustration 1 g03485478
Under the "Utilities" menu, select "Preferences" (Illustration 1).
Select “Modify” to change connection settings in ET. Refer to Illustration 1.
Show/hide table

Illustration 2 g03485516
Press the "Communications" tab. Change the connection type to "Ethernet Direct Connection". Refer to Illustration 2.
Show/hide table

Illustration 3 g03485581
Select the “Network Adapter Connection” that supports the “Ethernet Direct Connection.” If using the optional usb to Ethernet adapter, be sure to select this device from the drop-down menu.
Show/hide table

Illustration 4 g03485596
ET may attempt to reconnect, based on the change of Communication Protocol. Click "Yes"
Show/hide table

Illustration 5 g03485758
When ET reconnects, ET will attempt to detect an ECM using “IP Data Link".
Show/hide table

Illustration 6 g03485796
Select the Flash File when the ECM is detected and initiate the flash process. Wait until ET shows 100% completed, even if the display looks like it is working during flashing.
Show/hide table

Illustration 7 g06387536
The operator can skip the Operating System (O/S) flashing procedure if the same Operating System is already in the ECM. If the aforementioned information is true, press the "NO" button. Only the new application will be programmed.
Show/hide table

Illustration 8 g03485900
Click OK - If and when ET provides a warning that the Operating System will be changed.
Show/hide table

Illustration 9 g06387537
During the Flashing process, the display will reboot 1 to 2 times. During the rebooting process, the CAT ^® logo may be visible.
Show/hide table

Illustration 10 g06393884

Engine Speed Detected
Cat ET detects the engine speed.
Note: Any errors coming back from the ECM that would prevent the flash would occur at the beginning of the procedure. The error messages would occur after the user has clicked the Begin Flash button and before flashing actually begins.
Show/hide table

Illustration 11 g03494458
WAIT until “Flash Completed Successfully!” displays on the screen then, click “Cat ET.”
Show/hide table

Illustration 12 g03494483
After Flashing, change the Communication settings back to “Comm Adapter 3” (or “Comm Adapter 2”).
Connect to Cat ET.
Go to Display > Configurations.
Verify that the Product ID matches the Machine Product ID. If Product ID does not match, change the cycle power to the machine so the Display can re-request the Product ID from the Machine ECM.
Note: This machine cannot manually change product ID configuration. Changing the product ID configuration is supported in the ECM summary screen in ET, but not in the configuration area.
Show/hide table

Illustration 13 g03494716

Note: Illustration13 is a sample screenshot for D9TREX00301.
Flashing of the information display will vary between different machines. New Flashing information will be different.