Exhaust Manifold
Show/hide table
Illustration 1 | g01146165 |
(1) Exhaust manifold for the left bank of cylinders
(2) Exhaust manifold for the right bank of cylinders (4) Expansion joint |
Note: Apply 4C-5599 Anti-Seize Compound to the threads of the taperlock studs before assembly.
(3) Torque for two taperlock studs ...
(6) Torque for eight clamps ...
Show/hide table
Illustration 2 | g01427068 |
Tightening sequence for exhaust manifold |
Note: Use a centering tool in at least one oversize hole per manifold section in order to align the manifolds. Do not remove the centering tools until removal is required to tighten the locknuts.
Note: Apply 4C-5599 Anti-Seize Compound to the threads of the locknuts and the bearing surface of the locknuts and the spacers before assembly.
Use the following procedure to tighten the locknuts (5):
- Tighten the locknut (7) through locknut (18) in a numerical sequence that is shown in Illustration 2 to
20 ± 3 N·m (15 ± 2 lb ft) . - Again tighten the locknut (7) through locknut (18) in a numerical sequence that is shown in Illustration 2 to
38 ± 5 N·m (28 ± 4 lb ft) .
Caterpillar Information System:
Generation 3 DPFdm Diagnostic Module Installation Manual - California Only {1000, 1091, 7490} Generation 3 DPFdm Diagnostic Module Installation Manual - California Only {1000, 1091, 7490}
3176C, 3406E and 3456 Industrial Engines Configuration Parameters
C32 Marine Engine Fuel System Secondary Filter - Replace
3176C, 3406E and 3456 Industrial Engines Electronic Display Module
3176C, 3406E and 3456 Industrial Engines Engine Monitoring System
C32 Marine Generator Set Engine Oil and Filter - Change
3176C, 3406E and 3456 Industrial Engines Indicator Lamps
3608 Engine Camshaft Bearings - Install
3608 Engine Prelubrication Oil Pump - Install
3608 Engine Prelubrication Oil Pump - Remove
3608 Engine Fuel Pressure Control Valve - Install
3608 Engine Fuel Pressure Control Valve - Assemble
3608 Engine Prelubrication Oil Pump - Assemble
C27 and C32 Industrial and Petroleum Engines Vibration Damper and Pulley
3608 Engine Fuel Transfer Pump - Disassemble
C27 and C32 Industrial and Petroleum Engines Vibration Damper and Pulley
C-15, C-16, and C-18 Truck Engines Belt Tensioner
C15 and C18 Petroleum Generator Sets Model View Illustrations
C18 Petroleum Generator Sets Model View Illustrations
Product Link PL321 De-registration{7606} Product Link PL321 De-registration{7606}
C3.3 Industrial Engine Fuel System - Prime
3176C, 3406E and 3456 Industrial Engines Coolant Contains Oil
3176C, 3406E and 3456 Industrial Engines Coolant Level Is Low
2008/01/21 Improved Canister for the Filter Housing {3004, 3067, 5068, 5091, 5092, 5093}