Fuel Pressure Control Valve - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position fuel pressure control valve (2) on the front housing. Install bolts (4) that hold fuel pressure control valve (2) in place.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Show/hide table
Illustration 1 | g01208432 |
- Connect tube assemblies (1) and (3) to fuel pressure control valve (2) .
- Turn ON the fuel supply to the engine.
- Adjust the setscrew on fuel pressure control valve (2) in order to regulate the fuel pressure. Refer to Testing and Adjusting, "Fuel Pressure". Tighten the locknut in order to secure the setscrew.
Caterpillar Information System:
3608 Engine Fuel Pressure Control Valve - Assemble
3608 Engine Water Pump Seal - Install
3608 Engine Water Pump Seal - Remove
3608 Engine Auxiliary Water Pump - Assemble
2008/11/01 New Lines and Clamps are Now Used for the Air Control Group {1087, 7554}
3608 Engine Water Pump - Install
3608 Engine Water Pump - Remove
3608 Engine Cylinder Liner - Install
3176C, 3406E and 3456 Industrial Engines Component Location
G3520B Engine Prelube Pump - Inspect
C32 Marine Engine Cold Start Strategy
3176C, 3406E and 3456 Industrial Engines System Overview
3608 Engine Prelubrication Oil Pump - Remove
3608 Engine Prelubrication Oil Pump - Install
3608 Engine Camshaft Bearings - Install
3176C, 3406E and 3456 Industrial Engines Indicator Lamps
C32 Marine Generator Set Engine Oil and Filter - Change
3176C, 3406E and 3456 Industrial Engines Engine Monitoring System
3176C, 3406E and 3456 Industrial Engines Electronic Display Module
C32 Marine Engine Fuel System Secondary Filter - Replace
3176C, 3406E and 3456 Industrial Engines Configuration Parameters
Generation 3 DPFdm Diagnostic Module Installation Manual - California Only {1000, 1091, 7490} Generation 3 DPFdm Diagnostic Module Installation Manual - California Only {1000, 1091, 7490}
C27 and C32 Industrial and Petroleum Engines Exhaust Manifold
3608 Engine Prelubrication Oil Pump - Assemble