Prelubrication Oil Pump - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Put prelubrication oil pump (5) in position on the bracket on the engine oil pan. Install the bolts that hold the prelubrication oil pump in place.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Show/hide table
Illustration 1 | g00546100 |
Air Driven Prelube Pump |
Show/hide table
Illustration 2 | g00546101 |
Electrically Driven Prelube Pump |
- Install the elbows and tube (4) .
- Connect tube assembly (2) to check valve (3) .
- Connect harness assembly (6) to the electrically driven prelube pump.
- Connect tube assembly (1) to the air driven prelube pump.
- Fill the engine oil pan with oil to the correct level. Refer to Operation and Maintenance Manual, "Engine Oil - Change".
Caterpillar Information System:
3608 Engine Prelubrication Oil Pump - Remove
3608 Engine Fuel Pressure Control Valve - Install
3608 Engine Fuel Pressure Control Valve - Assemble
3608 Engine Water Pump Seal - Install
3608 Engine Water Pump Seal - Remove
3608 Engine Auxiliary Water Pump - Assemble
2008/11/01 New Lines and Clamps are Now Used for the Air Control Group {1087, 7554}
3608 Engine Water Pump - Install
3608 Engine Water Pump - Remove
3608 Engine Cylinder Liner - Install
3176C, 3406E and 3456 Industrial Engines Component Location
G3520B Engine Prelube Pump - Inspect
3608 Engine Camshaft Bearings - Install
3176C, 3406E and 3456 Industrial Engines Indicator Lamps
C32 Marine Generator Set Engine Oil and Filter - Change
3176C, 3406E and 3456 Industrial Engines Engine Monitoring System
3176C, 3406E and 3456 Industrial Engines Electronic Display Module
C32 Marine Engine Fuel System Secondary Filter - Replace
3176C, 3406E and 3456 Industrial Engines Configuration Parameters
Generation 3 DPFdm Diagnostic Module Installation Manual - California Only {1000, 1091, 7490} Generation 3 DPFdm Diagnostic Module Installation Manual - California Only {1000, 1091, 7490}
C27 and C32 Industrial and Petroleum Engines Exhaust Manifold
3608 Engine Prelubrication Oil Pump - Assemble
C27 and C32 Industrial and Petroleum Engines Vibration Damper and Pulley
3608 Engine Fuel Transfer Pump - Disassemble