Sprocket Segment - Remove and Install
Removal Procedure
- Clearly mark segment (2) that is selected for removal. Move the machine forward or backward until segment (2) is in the correct position.
Show/hide table
Illustration 1 | g00832194 |
- Remove five nuts (1) and five bolts (3). Remove segment (2) .
Show/hide table
Illustration 2 | g00823069 |
Installation Procedure
- Before you install the sprocket segment, apply SAE 30W oil to the threads of the bolts (3). Place segment (2) on the final drive. Install bolts (3) and nuts (1) .
Note: Install the bolts (3) with the washers against the final drive.
Show/hide table
Illustration 3 | g00823069 |
Show/hide table
Illustration 4 | g00832194 |
- Tighten nuts (1) to a torque of 300 ± 50 N·m (220 ± 40 lb ft). Then, tighten the nuts by an additional 120 degree turn. The final torque must be a minimum of 570 N·m (420 lb ft).
Caterpillar Information System:
D7R Track-Type TractorPower Train Track - Connect
D7R Track-Type TractorPower Train Track - Assemble
D7R Track-Type TractorPower Train Track - Disassemble
D7R Track-Type TractorPower Train Track - Separate
D7R Track-Type TractorPower Train Track Roller - Install
D7R Track-Type TractorPower Train Track Roller - Assemble
973 Track-Type Loader Steering Linkage - Lubricate
D7R Track-Type TractorPower Train Track Roller - Disassemble
963B Track-Type Loader Burn Prevention
D7R Track-Type TractorPower Train Track Roller - Remove
D7R Track-Type TractorPower Train Bottom Guard - Remove and Install
D9R Track-Type Tractor Equalizer Bar End Pins - Lubricate
611 Wheel Tractor-Scraper Cooling System Coolant (DEAC) - Change
D7R Track-Type TractorPower Train Track Roller Frame - Remove
D7R Track-Type TractorPower Train Pivot Shaft Seals-Disassemble
D7R Track-Type TractorPower Train Pivot Shaft Seals-Assemble
D7R Track-Type TractorPower Train Track Roller Frame - Install
D7R Track-Type TractorPower Train Front Track Roller Frame - Remove
D7R Track-Type TractorPower Train Front Track Roller Frame - Install
D8R Track-Type Tractor Hydraulic System Bulldozer and Ripper Control Linkage
D7R Track-Type TractorPower Train Track Adjuster - Remove
D7R Track-Type TractorPower Train Track Adjuster - Disassemble
D7R Track-Type TractorPower Train Track Adjuster - Assemble
IT14G Integrated Toolcarrier and 914G Wheel Loader Power Train Piston Motor (Hydrostatic)