131-4095 Tube Assembly May Lack Orifices Caterpillar


131-4095 Tube Assembly May Lack Orifices

Usage:

TRACK-TYPE TRACTORSD11N (74Z, 4HK),
D11R (8Z11-402) TRACK-TYPE TRACTORS

Problem:

The 131-4095 Tube Assembly provides lubrication to the bearings supporting the Bevel Pinion in updated D11N and D11R bevel and transfer gear groups. Refer to Special Instructions REHS0201-00 published December 12, 1997 for usage of this tube assembly. A tube assembly has been found in one dealer's inventory that lacked the two orifices that direct oil into the bearing. Inspection of the tube assemblies in inventory at one parts distribution center reviewed that 16 out of 21 lacked the necessary holes. Inventory of this tube assembly at all other parts distribution facilities is now being inspected.

Dealers are urged to immediately inspect their inventories of this tube assembly. Any tube assemblies without the necessary holes should be removed from inventory and held pending further investigation and instructions. Dealers should also inspect these tube assemblies during the rebuild of any D11 transmission, as we do not know at this time when this may have originated.

The two pictures below show the tube assemblies and the holes in question.


Illustration 1.

Location of the orifices


Illustration 2.

Close up view of the orifices

COPYRIGHT 2000 CATERPILLAR ALL RIGHTS RESERVED

Caterpillar Information System:

Field Returns Of Failed Actual Gear Position Sensors On D-Series Small Off-Highway Trucks, Wheel Tractor Scrapers, And Articulated Trucks Are Needed For failure Analysis Field Returns Of Failed Actual Gear Position Sensors On D-Series Small Off-Highway Trucks, Wheel Tractor Scrapers, And Articulated Trucks Are Needed For failure Analysis
Requirements For 111-2427 Clip When Performing PS40125 Requirements For 111-2427 Clip When Performing PS40125
VIMS May Reset When Loader Payload Data Is Downloaded With VIMSpc99 Or Accessed VIA The Loader Payload Menu VIMS May Reset When Loader Payload Data Is Downloaded With VIMSpc99 Or Accessed VIA The Loader Payload Menu
Diagnostic Code CID 0800 FMI 09 May Log Against VIMS At Power Up Diagnostic Code CID 0800 FMI 09 May Log Against VIMS At Power Up
Grapple Chattering When The Grapple Is Lowered At Idle Or At Low Engine Speeds Grapple Chattering When The Grapple Is Lowered At Idle Or At Low Engine Speeds
Test Cell Oil Screen And Oil Filter Test Cell Oil Screen And Oil Filter
Misalignment Between The Engine And The Hydrostatic Pump May Be Caused By Missing Flywheel Housing Dowel Pins Misalignment Between The Engine And The Hydrostatic Pump May Be Caused By Missing Flywheel Housing Dowel Pins
Air Cleaner May Allow Moisture Ingress Air Cleaner May Allow Moisture Ingress
Hydraulically Actuated Electronically Controlled Unit Injector (HEUI) Hydraulic Pump Hydraulically Actuated Electronically Controlled Unit Injector (HEUI) Hydraulic Pump
Modification To The Spacer Plate For The Recoil Spring Modification To The Spacer Plate For The Recoil Spring
Transmission May Neutralize While Operating The Transmission Directional Switch Transmission May Neutralize While Operating The Transmission Directional Switch
Do Not Use 183-1908 Or 183-7404 Flash Files On Track-Type Tractors And Pipelayers Do Not Use 183-1908 Or 183-7404 Flash Files On Track-Type Tractors And Pipelayers
Seats With Arm Rests Need Spacer Bars When The Seat Suspension Is Replaced Seats With Arm Rests Need Spacer Bars When The Seat Suspension Is Replaced
Transmission Controls (Shift Lever) May Fail Transmission Controls (Shift Lever) May Fail
Testing The Function Of The 3E6477 Relay Assembly (24 Volt) Testing The Function Of The 3E6477 Relay Assembly (24 Volt)
Debris From Manufacturing Operations Debris From Manufacturing Operations
Engine Continues To Run With Key Switch Off Engine Continues To Run With Key Switch Off
Failure Of The Friction Disc For The Joystick Hold Control Failure Of The Friction Disc For The Joystick Hold Control
Sand Blast Grid Sand Blast Grid
A New Battery Clip Is Now Used On The 980G Wheel Loader A New Battery Clip Is Now Used On The 980G Wheel Loader
Lights Flashing On New Caterpillar Radios (173-6530 Radio Group (AM/FM/WB) And 173-6532 Radio Group (AM/FM Cassette)) Lights Flashing On New Caterpillar Radios (173-6530 Radio Group (AM/FM/WB) And 173-6532 Radio Group (AM/FM Cassette))
Connecting Rod Bearings Connecting Rod Bearings
Bond Failure Of The Transmission Friction Disc Bond Failure Of The Transmission Friction Disc
167-6834 Wire Harness 167-6834 Wire Harness
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.