C7 Engines for Combat and Tactical Vehicles Caterpillar

Customer Specified Parameters Table

Usage:

C7 FML

Show/hide table

Table 1
Table for Customer Specified Parameter
Parameter	Available Range or Options	Default
"Selected Engine Rating"
"Rating Number"	Dependent on engine power
"ECM Identification Parameters"
"Vehicle ID"	17 Digits Available characters are dependent on the service tools.	all zeroes
"Truck Manufacturer Parameters"
"Truck Manufacturer"	"Other"	"Other"
"Vehicle Speed Parameters"
"Vehicle Speed Calibration"	2485 to 93226 PPKM (4000 to 150000 PPM)	Not Programmed
"Vehicle Speed CAL (J1939-Trans)"	0 to 43000 revolutions per km (0 to 65000 rpm)	Not Programmed
"Vehicle Speed CAL (J1939-ABS)"	0 to 6.550	Not Programmed
"Vehicle Speed Limit (VSL)"	48 to 204 km/h (30 to 127 mph)	204 km/h (127 mph)
"VSL Protection"	1700 to TEL rpm	TEL rpm
"Tachometer Calibration"	2.0 to 500.0 pulses per revolution	134.0 pulses per revolution
"Soft Vehicle Speed Limit"	"No" "Yes"	"No"
"Low Speed Range Axle Ratio"	0.00 to 19.99	0.00
"High Speed Range Axle Ratio"	0.0 to 9.99	0.00
"Cruise Control Parameters"
"Low Cruise Control Speed Set Limit"	24 to 204 km/h (15 to 127 mph)	204 km/h (127 mph)
"High Cruise Control Speed Set Limit"	32 to 204 km/h (20 to 127 mph)	204 km/h (127 mph)
"Exhaust Brake Mode"	"Coast" "Latch" "Manual"	"Manual"
"Auto Retarder in Cruise (0 = Off)"	0 to 16 km/h (0 to 10 mph)	0 km/h (0 mph)
"Auto Retarder in Cruise Increment"	0 to 8 km/h (0 to 5 mph)	0 km/h (0 mph)
"Cruise/Idle/PTO Switch Configuration"	"Set/Decel - Res/Accel" "Set/Accel - Res/Decel"	"Set/Accel - Res/Decel"
"Soft Cruise Control"	"Yes" "No"	"Yes"
"Idle Parameters"
"Idle Vehicle Speed Limit"	2 to 24 km/h (1 to 15 mph)	2 km/h (1 mph)
"Idle RPM Limit"	700 to TEL rpm	TEL rpm
"Idle/PTO RPM Ramp Rate"	5 to 1000 rpm/sec	50 rpm/sec
"Idle/PTO Bump RPM"	5 to 500 rpm	20 rpm
"Fast Idle RPM #1"	700 to TEL rpm	1000 rpm
"Fast Idle RPM #2"	700 to TEL rpm	0 rpm
"Warm up Mode Idle Speed"	700 to 1400 rpm	1000 rpm
"Dedicated PTO Parameters"
"PTO Configuration"	"Off" "Cab Switches" "Remote Switches" "Remote Throttle"	"Off"
"PTO Top Engine Limit"	700 to TEL rpm	TEL rpm
"PTO Engine RPM Set Speed (0 = Off)"	Low Idle to PTO TEL rpm	0 rpm
"PTO Engine RPM Set Speed A"	Low Idle to PTO TEL rpm	0 rpm
"PTO Engine RPM Set Speed B"	Low Idle to PTO TEL rpm	0 rpm
"PTO to Set Speed"	"Yes" "No"	"No"
"Maximum PTO Enable Speed"	700 to TEL rpm	TEL rpm
"PTO Cab Throttle RPM Limit"	"Low Idle" "TEL" "PTO TEL"	"TEL"
"PTO Kickout Vehicle Speed Limit"	2 to 204 km/h (1 to 127 mph)	2 km/h (1 mph)
"Max PTO Vehicle Speed"	24 to 204 km/h (15 to 127 mph)	204 km/h (127 mph)
"Torque Limit"	135 N·m (100 lb ft) to Rated Torque	2712 N·m (2000 lb ft)
"PTO Shutdown Time (0 = Off)"	3 to 1440 minutes	0 minutes
"PTO Activates Cooling Fan"	"Normal" "Continuous"	"Normal"
"Exhaust Brake Options"
"Exhaust Brake Warm Up Enable"	"None" "Warm up Only" "Exhaust Brake Only" "Exhaust Brake & Warm Up"	"Exhaust Brake Only"
"Engine/Gear Parameters"
"Lower Gears Engine RPM Limit"	1500 to TEL rpm	TEL rpm
"Lower Gears Turn Off Speed"	2 to 24 km/h (1 to 15 mph)	2 km/h (1 mph)
"Intermediate Gears Engine RPM Limit"	1500 to TEL rpm	TEL rpm
"Intermediate Gears Turn Off Speed"	16 to 80 km/h (10 to 50 mph)	16 km/h (10 mph)
"Gear Down Protection RPM Limit"	1700 to TEL rpm	TEL rpm
"Gear Down Protection Turn On Speed"	48 to 204 km/h (30 to 127 mph)	204 km/h (127 mph)
"Top Engine Limit" (TEL)	Dependent on the engine and the rating	Dependent on the engine rating
"Low Idle Engine RPM"	700 to 800 rpm	700 rpm
"Transmission Style"	"Manual Option 1" "Automatic Option 1" "Automatic Option 2" "Automatic Option 3" "Automatic Option 4" "AT/MT/HT Option 1" "AT/MT/HT Option 2" "AT/MT/HT Option 3" "AT/MT/HT Option 4"	"Manual Option 1"
"AT/MT/HT Part Throttle Shift Speed"	"Low:80% Enable/65% Disable" "Medium:70% Enable/55% Disable" "High:60% Enable/45% Disable"	"High: 60% Enable/45% Disable"
"Starting Aid Output"	"Off" "Automatic"	"Off"
"Governor Type"	"Min/Max" "Full Range"	"Full Range"
"Smart Idle Parameters"
"Battery Monitor & Engine Control Voltage"	0 to 25.5 Volts	0 Volts
"Battery Monitor Low Idle Speed Monitor"	700 to TEL rpm	1000 rpm
"Timer Parameters"
"Idle Shutdown Time (0 = Off)"	3 to 1440 minutes	0 minutes
"Allow Idle Shutdown Override"	"Yes" "No"	"Yes"
"A/C Switch Fan-On Time (0 = Off)"	0 to 600 seconds	0 seconds
"Fan with Engine Brake On"	"Yes" "No"	"No"
"Engine Monitoring Parameters"
"Engine Monitoring Mode"	"Warning"	"Warning"
"Engine Monitoring Lamps"	"Warning Lamp" "Option 1"	"Warning Lamp"
"Coolant Level Sensor"	"No" "4 Pin" "2 Wire Float"	"No"
"Engine Oil Pressure Sensor"	"Installed" "Not Installed"	"Not Installed"
"Maintenance Parameters"
"Maintenance Indicator Mode"	"Off" "Manual Distance" "Manual Hours" "Automatic Distance" "Automatic Hours"	"Off"
"PM 1 Interval (Manual Maintenance Indicator Mode)"	8050 to 56325 km (5000 to 35000 miles) or 100 to 750 hours	19312 kilometers (12000 miles)
"Engine Oil Capacity (Automatic Maintenance Indicator Mode)"	19 to 57 L (20 to 60 qt)	31 L (33 qt)
"Trip Parameters"
"Dash - PM 1 Reset"	"Yes" "No"	"No"
"Dash - Customer Parameters"	"Yes" "No"	"No"
"Theft Deterrent System Control"	"Yes" "No" "Auto-Enable"	"No"
"Theft Deterrent Password"	Four Characters	0000
"Quick Stop Rate"	0 to 205 km/h per second (0 to 128 mph per second)	0 km/h per second (0 mph per second)
"Input Selections"
"Fan Override Switch"	"None" "J1939 Body Controller" "J1939 Cab Controller" "J1939 Instrument Cluster"	"None"
"Transmission Neutral Switch"	"None" "J1/P1:62" "J1939"	"J1/P1:62"
"Exhaust Brake Switch"	"None" "J1/P1:16" "J1939 Body Controller" "J1939 Cab Controller" "J1939 Instrument Cluster"	"None"
"Ignore Brake/Clutch Switch"	"None" "J1/P1:47"	"None"
"Two Speed Axle Switch"	"None" "J1/P1:6"	"None"
"Vehicle Speed Input"	"J1/P1:32 & 33" "J1939-ABS" "J1939-Trans"	"J1/P1:32 & 33"
"PTO Engine Shutdown Switch"	"None" "J1/P1:7" "J1/P1:23"	"None"
"Torque Limit Switch"	"None" "J1/P1:7" "J1/P1:23"	"None"
"PTO Engine RPM Set Speed Input A"	"None" "J1/P1:46"	"None"
"PTO Engine RPM Set Speed Input B"	"None" "J1/P1:7" "J1/P1:23"	"None"
"Diagnostic Enable"	"None" "J1/P1:46" "J1939 Body Controller" "J1939 Cab Controller" "J1939 Instrument Cluster"	"None"
"Cruise Control On/Off Switch"	"J1/P1:59" "J1939 Body Controller" "J1939 Cab Controller" "J1939 Instrument Cluster"	"J1/P1:59"
"Cruise Control Set/Resume Switch"	"J1/P1:35 & 44" "J1939 Body Controller" "J1939 Cab Controller" "J1939 Instrument Cluster"	"J1/P1:35 & 44"
"Cruise Control Pause Switch"	"None" "J1939 Body Controller" "J1939 Cab Controller" "J1939 Instrument Cluster"	"None"
"Clutch Pedal Position Switch"	"J1/P1:22" "J1939 Body Controller" "J1939 Cab Controller" "J1939 Instrument Cluster"	"J1/P1:22"
"Service Brake Pedal Position Switch #1"	"J1/P1:45" "J1939 Body Controller" "J1939 Cab Controller" "J1939 Instrument Cluster"	"J1/P1:45"
"Accelerator Pedal Position"	"None" "J1/P1:66"	"J1/P1:66"
"A/C High Pressure Switch"	"None" "J1/P1:41"	"J1/P1:41"
"Output Selections"
"Fan Control Type"	"None" "On/Off" "Variable Speed Option S"	"None"
"PTO Active Output"	"None" "J1/P1:19"	"None"
"PTO Switch On Lamp"	"None" "J1/P1:30"	"None"
"Wait To Start Lamp"	"None" "J1/P1:31"	"None"
"Fast Idle Enable Lamp"	"None" "J1/P1:31" "J1/P1:21"	"None"
"Change Oil Lamp"	"None" "J1/P1:30"	"None"
"Customer Passwords"
"Customer Password #1"	8 Digits Available characters are dependent on the service tools.
"Customer Password #2"
"Data Link Parameters"
"Powertrain Data Link"	"None" "J1939"	"None"