Crankshaft Front Seal and Wear Sleeve - Remove
Show/hide table
Required Tools | |||
Tooling | Part Number | Description | Qty |
A | 1P-3075 | Slide Hammer Puller | 1 |
B | 5P-7312 | Seal Distorter | 1 |
C | 5P-7315 | Distorter Ring | 1 |
Start By:
- Remove the vibration damper and the pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove" for the engine that is being serviced.
Note: When you replace the front seal always replace the wear sleeve.
- Remove crankshaft front seal (1) with Tooling (A).
Show/hide table
Illustration 2 g00988254 - Install Tooling (C) into the seal bore.
- Install Tooling (B) between Tooling (C) and the wear sleeve.
- Turn Tooling (B) until the edge of the tool makes a flat place (crease) in the wear sleeve. Perform this procedure in two or more places until the wear sleeve is loose.
- Remove Tooling (C) and the wear sleeve by hand.
Show/hide table
Illustration 1 | g00988251 |
Typical Example |
Caterpillar Information System:
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Install
G3304 and G3306 Engines Vibration Damper and Pulley - Install
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Remove
C15 On-Highway Engines Lubrication System
3044C Industrial Engine Cooling System Coolant (DEAC) - Change
3044C Industrial Engine After Stopping Engine
3044C Industrial Engine and Engines for Caterpillar Built Machines Glow Plugs
C7 On-highway Engine Engine Oil Filter Base - Remove
3516B HD Generator Set Overhaul (Top End)
3126B Petroleum Engine Excessive White Smoke
G3304 and G3306 Engines Vibration Damper and Pulley - Remove
3516B HD Generator Set Overhaul (Major)
C7 Engines for Caterpillar Built Machines Connecting Rod Bearings - Remove
3044C Industrial Engine Engine Oil and Filter - Change
C7 On-highway Engine Connecting Rod Bearings - Install
C7 Engines for Combat and Tactical Vehicles System Overview
C7 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Remove
G3304 and G3306 Engines Crankshaft Front Seal and Wear Sleeve - Install
C7 and C9 On-Highway Engines Engine Speed/Timing Sensor - Calibrate
C7 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Install
C7 Marine Engines Crankshaft - Remove
C7 Marine Engines Crankshaft - Install
C7 Engines for Combat and Tactical Vehicles Customer Specified Parameters Table
C7 Engines for Combat and Tactical Vehicles Customer Specified Parameters Worksheet