After Stopping Engine
注: 检查发电机机油之前,停止运行发动机至少10分钟以便使发动机机油有充分时间回到油底壳。
- 检查发动机曲轴箱机油油位。 保持机油油位在油尺的"最低 (MIN)"标记和"最高(MAX)"标记之间。
- 如有必要,进行小的调整。 修理每一处渗漏并拧紧任何松动的螺栓。
- 记下工时表的读数。 按本操作和保养手册, "保养部分的保养周期表"所述进行保养。
- 加满燃油箱以便于防止油箱中积聚湿气。 燃油箱不要加油过满。
Show/hide table
注意 |
---|
只使用操作和保养手册冷却液规格中建议使用的防冻剂/冷却液混合液。 不这样做会造成发动机损坏。 |
- 让发动机冷却。 检查冷却液液位。 将冷却液液位保持在加注管底部以下 13 mm (0.5 inch)之内。
- 如果预料到结冻温度,要检查冷却液的防冻剂保护是否正确。 必须保护冷却系统,以防其在预计的最低外部温度下结冻。 如果必要,添加适当的冷却液/水混合液。
- 对所有被驱动的设备进行必需的定期保养。 此保养会在原设备制造商(OEM)的使用说明书中述及。
Caterpillar Information System:
3044C Industrial Engine and Engines for Caterpillar Built Machines Glow Plugs
C7 On-highway Engine Engine Oil Filter Base - Remove
3516B HD Generator Set Overhaul (Top End)
3126B Petroleum Engine Excessive White Smoke
G3304 and G3306 Engines Vibration Damper and Pulley - Remove
3516B HD Generator Set Overhaul (Major)
C9 Urban Transit Bus Engine Air Inlet Cover - Install
C9 Urban Transit Bus Engine Air Inlet Cover - Remove
C1.5 and C2.2 Generator General Information
G3304 and G3306 Engines Engine Oil Cooler - Assemble
C7 On-Highway Engine Lifter Group - Remove and Install
C15 Petroleum Generator Set Engines Gear Group (Front)
3044C Industrial Engine Cooling System Coolant (DEAC) - Change
C15 On-Highway Engines Lubrication System
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Remove
G3304 and G3306 Engines Vibration Damper and Pulley - Install
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Install
G3304 and G3306 Engines Crankshaft Front Seal and Wear Sleeve - Remove
C7 Engines for Caterpillar Built Machines Connecting Rod Bearings - Remove
3044C Industrial Engine Engine Oil and Filter - Change
C7 On-highway Engine Connecting Rod Bearings - Install
C7 Engines for Combat and Tactical Vehicles System Overview
C7 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Remove
G3304 and G3306 Engines Crankshaft Front Seal and Wear Sleeve - Install