Engine Oil Cooler - Assemble
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the core of engine oil cooler (1) with a
3.2 mm (0.125 inch) diameter rod.Show/hide tableIllustration 2 g00987983 - Install two O-ring seals (2) in position on elbows (3).
- Install two elbows (3) on the engine oil cooler.
Show/hide table
Illustration 3 g00987984 - Install a new gasket (4) on bonnet (5).
- Use four bolts in order to install bonnet (5).
Show/hide table
Illustration 1 | g00987982 |
End By:
- Install the engine oil cooler. Refer to Disassembly and Assembly, "Engine Oil Cooler - Install" for the engine that is being serviced.
Caterpillar Information System:
C7 On-Highway Engine Lifter Group - Remove and Install
C15 Petroleum Generator Set Engines Gear Group (Front)
C7 Engines for Caterpillar Built Machines Unit Injector - Install
C7 Engines for Caterpillar Built Machines Unit Injector - Remove
C7 On-Highway Engine Engine Oil Pan - Remove and Install
3046 Engine for Caterpillar Built Machines Flywheel Housing - Inspect
C7 Marine Engines Engine Oil Pump - Install
C7 Marine Engines Engine Oil Pump - Assemble
C9 On-Highway Engines Cooling System - Test
C15 Petroleum Generator Set Engines Electronic Unit Injector Rocker Arm
3516B HD Generator Set Reference Information
C9 Urban Transit Bus Engine Vibration Damper and Pulley - Remove and Install
C1.5 and C2.2 Generator General Information
C9 Urban Transit Bus Engine Air Inlet Cover - Remove
C9 Urban Transit Bus Engine Air Inlet Cover - Install
3516B HD Generator Set Overhaul (Major)
G3304 and G3306 Engines Vibration Damper and Pulley - Remove
3126B Petroleum Engine Excessive White Smoke
3516B HD Generator Set Overhaul (Top End)
C7 On-highway Engine Engine Oil Filter Base - Remove
3044C Industrial Engine and Engines for Caterpillar Built Machines Glow Plugs
3044C Industrial Engine After Stopping Engine
3044C Industrial Engine Cooling System Coolant (DEAC) - Change
C15 On-Highway Engines Lubrication System