Unit Injector - Remove
拆卸步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件描述     | 数量     |
A     | 367-3070     | 喷油器安装和拆卸工具     | 1     |
开始:
- 拆下气门机构盖。 请参阅拆解和组装, "气门机构盖 - 拆卸和安装"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 从缸盖上排放冷却液、机油和燃油。 拆下机油道螺塞 (1) 、燃油道螺塞 (2) 和冷却液管路 (3) 。
Show/hide table
图 1 | g03007076 |
- 断开线束组件 (4) 。
Show/hide table
图 2 | g03028024 |
- 将内六角头螺栓 (6) 从单体喷油器 (5) 上拆下。
- 安装工具 (A) 。 使用工具 (A) 拆下单体喷油器 (5) 。
Show/hide table
图 3 | g03028041 |
- 从单体喷油器 (5) 上拆下 O 形密封圈 (10) 、 (11) 和 (12) 。
注: 不要使用钢丝刷清理单体喷油器顶部。 将会导致单体喷油器损坏。
Show/hide table
图 4 | g03009616 |
- 拆卸备用环 (8) 、备用环 (9) 和备用环 (13) 。
Caterpillar Information System:
C7 On-Highway Engine Engine Oil Pan - Remove and Install
3046 Engine for Caterpillar Built Machines Flywheel Housing - Inspect
C7 Marine Engines Engine Oil Pump - Install
C7 Marine Engines Engine Oil Pump - Assemble
C9 On-Highway Engines Cooling System - Test
C15 Petroleum Generator Set Engines Electronic Unit Injector Rocker Arm
3516B HD Generator Set Reference Information
C9 Urban Transit Bus Engine Vibration Damper and Pulley - Remove and Install
C7 Marine Engines Engine Oil Pump - Disassemble
C15 On-highway Engine Fuel Filter Base
C7 Marine Engines Engine Oil Pump - Remove
C7 PETROLEUM Petroleum Engine Valve Mechanism Cover - Remove and Install
C7 Engines for Caterpillar Built Machines Unit Injector - Install
C15 Petroleum Generator Set Engines Gear Group (Front)
C7 On-Highway Engine Lifter Group - Remove and Install
G3304 and G3306 Engines Engine Oil Cooler - Assemble
C1.5 and C2.2 Generator General Information
C9 Urban Transit Bus Engine Air Inlet Cover - Remove
C9 Urban Transit Bus Engine Air Inlet Cover - Install
3516B HD Generator Set Overhaul (Major)
G3304 and G3306 Engines Vibration Damper and Pulley - Remove
3126B Petroleum Engine Excessive White Smoke
3516B HD Generator Set Overhaul (Top End)
C7 On-highway Engine Engine Oil Filter Base - Remove