Engine Oil Pump - Assemble
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
B | 1P-0510 | Driver Gp | 1 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (B) and press drive gear (9) on the shaft assembly until drive gear (9) is flush with the end of the shaft assembly.
- Install bearing (6) in idler gear (7). Install bearing (6) so the distance between the hub bolt face of idler gear and bearing (6) is
0.75 ± 0.25 mm (0.030 ± 0.010 inch) . - Install idler gear (7) on shaft (8). Install bolt (5). Tighten bolt (5) to a torque of
70 ± 15 N·m (52 ± 11 lb ft) . - Position the gasket and oil pickup tube (2) onto engine oil pump (10). Install bolts (1).
- Position the O-ring seal and outlet elbow (4) onto engine oil pump (10). Install bolt (3).
Show/hide table
Illustration 1 | g01127673 |
Show/hide table
Illustration 2 | g01127669 |
End By:
- Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".
Caterpillar Information System:
C9 On-Highway Engines Cooling System - Test
C15 Petroleum Generator Set Engines Electronic Unit Injector Rocker Arm
3516B HD Generator Set Reference Information
C9 Urban Transit Bus Engine Vibration Damper and Pulley - Remove and Install
C7 Marine Engines Engine Oil Pump - Disassemble
C15 On-highway Engine Fuel Filter Base
C7 Marine Engines Engine Oil Pump - Remove
C7 PETROLEUM Petroleum Engine Valve Mechanism Cover - Remove and Install
C7 Marine Engines Rocker Shaft and Pushrod - Install
C4.4 (Mech) Industrial Engine Battery - Test
C7 Marine Engines Rocker Shaft and Pushrod - Remove
C7 On-Highway Engine Fuel Filter Base - Remove and Install
C7 Marine Engines Engine Oil Pump - Install
3046 Engine for Caterpillar Built Machines Flywheel Housing - Inspect
C7 On-Highway Engine Engine Oil Pan - Remove and Install
C7 Engines for Caterpillar Built Machines Unit Injector - Remove
C7 Engines for Caterpillar Built Machines Unit Injector - Install
C15 Petroleum Generator Set Engines Gear Group (Front)
C7 On-Highway Engine Lifter Group - Remove and Install
G3304 and G3306 Engines Engine Oil Cooler - Assemble
C1.5 and C2.2 Generator General Information
C9 Urban Transit Bus Engine Air Inlet Cover - Remove
C9 Urban Transit Bus Engine Air Inlet Cover - Install
3516B HD Generator Set Overhaul (Major)