Air Inlet Cover - Remove
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assemblies (1) and (2) .
Show/hide table
Illustration 1 | g01137540 |
- Disconnect hose assembly (6) .
- Remove bolts (3) and air inlet cover (7) .
- Remove ground straps (5) (if equipped).
- Remove inlet manifold heater (4) from the cylinder head.
Caterpillar Information System:
C1.5 and C2.2 Generator General Information
G3304 and G3306 Engines Engine Oil Cooler - Assemble
C7 On-Highway Engine Lifter Group - Remove and Install
C15 Petroleum Generator Set Engines Gear Group (Front)
C7 Engines for Caterpillar Built Machines Unit Injector - Install
C7 Engines for Caterpillar Built Machines Unit Injector - Remove
C7 On-Highway Engine Engine Oil Pan - Remove and Install
3046 Engine for Caterpillar Built Machines Flywheel Housing - Inspect
C7 Marine Engines Engine Oil Pump - Install
C7 Marine Engines Engine Oil Pump - Assemble
C9 On-Highway Engines Cooling System - Test
C15 Petroleum Generator Set Engines Electronic Unit Injector Rocker Arm
C9 Urban Transit Bus Engine Air Inlet Cover - Install
3516B HD Generator Set Overhaul (Major)
G3304 and G3306 Engines Vibration Damper and Pulley - Remove
3126B Petroleum Engine Excessive White Smoke
3516B HD Generator Set Overhaul (Top End)
C7 On-highway Engine Engine Oil Filter Base - Remove
3044C Industrial Engine and Engines for Caterpillar Built Machines Glow Plugs
3044C Industrial Engine After Stopping Engine
3044C Industrial Engine Cooling System Coolant (DEAC) - Change
C15 On-Highway Engines Lubrication System
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Remove
G3304 and G3306 Engines Vibration Damper and Pulley - Install