Vibration Damper and Pulley - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 1P-0820     | Hydraulic Puller     | 1     |
3H-0465 | Push-Puller Plate     | 4     | |
1B-4207 | Full Nut     | 2     | |
5P-5228 | Adapter     | 2     | |
5F-7342 | Adapter     | 2     | |
8B-7560 | Step Plate     | 1     | |
FT-0915 | Adapter     | 1     | |
9U-6600 | Hand Hydraulic Pump     | 1     |
- Remove bolt (1) and the washer.
Show/hide table
Illustration 1 | g00988172 |
- Install two 19 mm (0.75 inch) flat washers (2) on bolt (1) . Install bolt (1) into the crankshaft.
Show/hide table
Illustration 2 | g00988118 |
- Install Tooling (A) . Use Tooling (A) in order to loosen the pulley and vibration damper (3) .
Note: Bolt (1) will keep the pulley and vibration damper (3) on the crankshaft when the pulley and the vibration damper are loosened with Tooling (A) .
Show/hide table
Illustration 3 | g00988142 |
- Remove Tooling (A) .
- Carefully remove bolt (1) , the washer, and two flat washers (2) from the crankshaft.
Show/hide table
Illustration 4 | g00988118 |
- Carefully remove the pulley and vibration damper (3) .
Show/hide table
Illustration 5 | g00988158 |
Caterpillar Information System:
3516B HD Generator Set Overhaul (Major)
C9 Urban Transit Bus Engine Air Inlet Cover - Install
C9 Urban Transit Bus Engine Air Inlet Cover - Remove
C1.5 and C2.2 Generator General Information
G3304 and G3306 Engines Engine Oil Cooler - Assemble
C7 On-Highway Engine Lifter Group - Remove and Install
C15 Petroleum Generator Set Engines Gear Group (Front)
C7 Engines for Caterpillar Built Machines Unit Injector - Install
C7 Engines for Caterpillar Built Machines Unit Injector - Remove
C7 On-Highway Engine Engine Oil Pan - Remove and Install
3046 Engine for Caterpillar Built Machines Flywheel Housing - Inspect
C7 Marine Engines Engine Oil Pump - Install
3126B Petroleum Engine Excessive White Smoke
3516B HD Generator Set Overhaul (Top End)
C7 On-highway Engine Engine Oil Filter Base - Remove
3044C Industrial Engine and Engines for Caterpillar Built Machines Glow Plugs
3044C Industrial Engine After Stopping Engine
3044C Industrial Engine Cooling System Coolant (DEAC) - Change
C15 On-Highway Engines Lubrication System
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Remove
G3304 and G3306 Engines Vibration Damper and Pulley - Install
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Install
G3304 and G3306 Engines Crankshaft Front Seal and Wear Sleeve - Remove
C7 Engines for Caterpillar Built Machines Connecting Rod Bearings - Remove