Air Inlet Cover - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 4C-9500     | Quick Cure Primer     | 1     |
B     | 8C-8422     | Sealant     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the inlet manifold heater face with cleaning solvent. Apply Tooling (A) to the inlet manifold heater face. Allow Tooling (A) to dry for 3 to 5 minutes. Apply Tooling (B) to the joint face and spread uniformly. Heater assembly must be installed and tightened within 10 minutes.
- Position air inlet cover (7) and inlet manifold heater (4) on the cylinder block. Install bolts (3) . Tighten bolts (3) to a torque of 28 ± 7 N·m (21 ± 5 lb ft).
Show/hide table
Illustration 1 | g01137540 |
- Install ground straps (5) (if equipped).
- Connect hose assembly (6) to air inlet cover (7) .
- Connect harness assemblies (1) and (2) .
Note: The brackets that hold down the harness assemblies must be installed in the proper locations.
Caterpillar Information System:
C9 Urban Transit Bus Engine Air Inlet Cover - Remove
C1.5 and C2.2 Generator General Information
G3304 and G3306 Engines Engine Oil Cooler - Assemble
C7 On-Highway Engine Lifter Group - Remove and Install
C15 Petroleum Generator Set Engines Gear Group (Front)
C7 Engines for Caterpillar Built Machines Unit Injector - Install
C7 Engines for Caterpillar Built Machines Unit Injector - Remove
C7 On-Highway Engine Engine Oil Pan - Remove and Install
3046 Engine for Caterpillar Built Machines Flywheel Housing - Inspect
C7 Marine Engines Engine Oil Pump - Install
C7 Marine Engines Engine Oil Pump - Assemble
C9 On-Highway Engines Cooling System - Test
3516B HD Generator Set Overhaul (Major)
G3304 and G3306 Engines Vibration Damper and Pulley - Remove
3126B Petroleum Engine Excessive White Smoke
3516B HD Generator Set Overhaul (Top End)
C7 On-highway Engine Engine Oil Filter Base - Remove
3044C Industrial Engine and Engines for Caterpillar Built Machines Glow Plugs
3044C Industrial Engine After Stopping Engine
3044C Industrial Engine Cooling System Coolant (DEAC) - Change
C15 On-Highway Engines Lubrication System
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Remove
G3304 and G3306 Engines Vibration Damper and Pulley - Install
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Install