Connecting Rod Bearings - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g00988234 |
- Install a new lower half connecting rod bearing (4) in connecting rod bearing cap (2) .
Note: Apply clean engine oil on the connecting rod bearings for final assembly.
- Install a new upper half connecting rod bearing (4) in connecting rod (3) .
- Pull connecting rod (3) onto the crankshaft.
- Check the bearing clearance. Refer to Disassembly and Assembly, "Bearing Clearance - Check".
- Install connecting rod bearing cap (2) and connecting rod bolts (1). Ensure that the number on the side of connecting rod bearing cap (2) is on the same side as the number on connecting rod (3) .
- Tighten connecting rod bolts (1) to a torque of 54 ± 5 N·m (40 ± 4 lb ft).
- Place an index mark on each connecting rod cap bolt. Tighten each bolt (1) for an additional 60 ± 5 degrees (1/6 of a turn).
- Repeat Steps 1 through 7 in order to install the remainder of the connecting rod bearings.
End By: Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".
Caterpillar Information System:
3044C Industrial Engine Engine Oil and Filter - Change
C7 Engines for Caterpillar Built Machines Connecting Rod Bearings - Remove
G3304 and G3306 Engines Crankshaft Front Seal and Wear Sleeve - Remove
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Install
G3304 and G3306 Engines Vibration Damper and Pulley - Install
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Remove
C15 On-Highway Engines Lubrication System
3044C Industrial Engine Cooling System Coolant (DEAC) - Change
3044C Industrial Engine After Stopping Engine
3044C Industrial Engine and Engines for Caterpillar Built Machines Glow Plugs
C7 On-highway Engine Engine Oil Filter Base - Remove
3516B HD Generator Set Overhaul (Top End)
C7 Engines for Combat and Tactical Vehicles System Overview
C7 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Remove
G3304 and G3306 Engines Crankshaft Front Seal and Wear Sleeve - Install
C7 and C9 On-Highway Engines Engine Speed/Timing Sensor - Calibrate
C7 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Install
C7 Marine Engines Crankshaft - Remove
C7 Marine Engines Crankshaft - Install
C7 Engines for Combat and Tactical Vehicles Customer Specified Parameters Table
C7 Engines for Combat and Tactical Vehicles Customer Specified Parameters Worksheet
C7 On-Highway Engine Unit Injector Hydraulic Pump - Remove
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
G3304 and G3306 Engines Engine Support - Remove and Install