Crankshaft - Remove
Start By:
- Remove the connecting rod bearings. Refer to Disassembly and Assembly, "Connecting Rod Bearings - Remove".
- Remove the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Remove".
- Remove the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (2) and main bearing caps (3).
- Attach a suitable lifting device to each end of crankshaft (1). The weight of crankshaft (1) is approximately
62 kg (137 lb) . Carefully remove crankshaft (1) from the cylinder block. - Remove the main bearings from the cylinder block. Remove the main bearings from the main bearing caps.
Show/hide table
Illustration 1 | g01128041 |
Caterpillar Information System:
C7 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Install
C7 and C9 On-Highway Engines Engine Speed/Timing Sensor - Calibrate
G3304 and G3306 Engines Crankshaft Front Seal and Wear Sleeve - Install
C7 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Remove
C7 Engines for Combat and Tactical Vehicles System Overview
C7 On-highway Engine Connecting Rod Bearings - Install
3044C Industrial Engine Engine Oil and Filter - Change
C7 Engines for Caterpillar Built Machines Connecting Rod Bearings - Remove
G3304 and G3306 Engines Crankshaft Front Seal and Wear Sleeve - Remove
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Install
G3304 and G3306 Engines Vibration Damper and Pulley - Install
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Remove
C7 Marine Engines Crankshaft - Install
C7 Engines for Combat and Tactical Vehicles Customer Specified Parameters Table
C7 Engines for Combat and Tactical Vehicles Customer Specified Parameters Worksheet
C7 On-Highway Engine Unit Injector Hydraulic Pump - Remove
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
G3304 and G3306 Engines Engine Support - Remove and Install
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
C7 On-Highway Engine Engine Oil Filter Base and Oil Cooler - Install
C7 Engines for Caterpillar Built Machines Crankshaft Gear - Remove and Install
3500B and 3500C Marine Propulsion Engines Air Shutoff System
3500B and 3500C Marine Propulsion Engines Analog Sensor Supply
3500B and 3500C Marine Propulsion Engines Cat Data Link