G3612 and G3616 Engines Caterpillar


Ignition Wiring Harness - Remove and Install

Usage:

G3612 BKE

拆卸步骤


注意

保持所有零件清洁无杂质。

杂质会造成快速磨损並縮短部件使用寿命。


表 1
所需工具 
工具  零件号  零件说明  数量 
A  151-6320  拆卸工具 


    图 1g00876151

  1. 切断供电。

  2. 断开主点火线束 (1)。

  3. 将线束 (3) 从壳体 (2) 上断开。


    图 2g00876154

  4. 卸下固定主点火线 (4) 的扎带 (5)。

  5. 使用工具 (A) 将主点火线从电子控制模块(ECM)的接头上卸下。

  6. 从 ECM 接线盒(未显示)底部断开点火配线线束。

  7. 从接线盒中拉出主点火线。


    图 3g00876157

  8. 卸下安装螺栓 (6)。

  9. 小心地从支架 (7) 上提起壳体。

安装步骤


注意

保持所有零件清洁无杂质。

杂质会造成快速磨损並縮短部件使用寿命。




    图 4g00876157

  1. 小心地将壳体放在支架 (7) 上。

  2. 安装安装螺栓 (6)。


    图 5g00876154

  3. 将主点火线 (4) 穿过接线盒。

  4. 将点火配线线束连接至 ECM 接线盒(未显示)底部。

  5. 将主点火线插入 ECM 上的接头。

  6. 安装扎带 (5)。


    图 6g00876151

  7. 连接线束 (3) 至壳体 (2)。

  8. 连接主点火线束 (1)。

  9. 重新供电。

Caterpillar Information System:

2002/04/01 Change to Disassembly and Assembly Manual {1157}
3412E and C30 Engines Piston and Rings
3500 Generator Set Engines Time Delay Relay
2002/03/01 Change to Disassembly and Assembly Manual {1157}
G3612 and G3616 Engines Inlet Air Temperature Sensor - Remove and Install
3056E Industrial Engine Exhaust Manifold
G3612 and G3616 Engines Electronic Control Module - Remove and Install
2002/03/01 New Specification For The Minimum Fuel Pressure At The Inlet To The Fuel Transfer Pump {1274}
G3612 and G3616 Engines Integrated Combustion Sensing Module (ICSM) - Remove and Install
Setup of the Machine Security System{7631} Setup of the Machine Security System{7631}
3176C and 3196 Engines for Caterpillar Built Machines Connecting Rod
G3612 and G3616 Engines Water Pump Pressure Switch - Remove and Install
3126E On-highway Engine Engine Oil Pump - Disassemble
3126E On-highway Engine Engine Oil Pump - Assemble
3500 Generator Set Engines Sending Unit - Engine Oil Pressure
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Sending Unit
G3612 and G3616 Engines Engine Speed/Timing Sensor - Remove and Install
2002/03/01 Change to Specifications Manual {1157}
G3408C and G3412C Engines Carburetor Control Linkage
C-12 Marine Engines Fuel Filter Base - Remove
C-12 Marine Engines Fuel Filter Base - Install
C280-16 Petroleum Engine Pressure Switch
3126B Marine Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
3500 Generator Set Engines Pressure Switch
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.