Carburetor Control Linkage
Show/hide table
Illustration 1 | g01401626 |
Side view (1) Full load position (maximum fuel) |
(A) Angle between vertical and full load position ... 70 degrees
Use the following procedure to install the actuator lever:
- Hold the actuator control shaft in the SHUTOFF position (2) .
- Loosen bolt (8) and rotate the lever (7) to the closed angle (D) that is 48 degrees.
- Tighten bolt (8) .
Use the following procedure to install the carburetor lever:
- Hold the throttle plate closed.
- Loosen bolt (5) and rotate carburetor lever (4) to closed angle (B) that is 5 degrees.
- Tighten bolt (5) .
Use the following procedure to install the carburetor control rod:
- Hold carburetor lever (4) in the SHUTOFF position (2) .
- Adjust carburetor control rod (3) until the rod fits between lever (7) and carburetor lever (4) .
- Ensure that there is no binding during full travel of the control linkage.
- Torque the jam nuts (6) to 13 ± 3 N·m (115 ± 27 lb in).
(C) Approximate length of the carburetor control rod. ... 440 mm (17.3 inch)
Caterpillar Information System:
2002/03/01 Change to Specifications Manual {1157}
G3612 and G3616 Engines Engine Speed/Timing Sensor - Remove and Install
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Sending Unit
3500 Generator Set Engines Sending Unit - Engine Oil Pressure
3126E On-highway Engine Engine Oil Pump - Assemble
3126E On-highway Engine Engine Oil Pump - Disassemble
G3612 and G3616 Engines Ignition Wiring Harness - Remove and Install
2002/04/01 Change to Disassembly and Assembly Manual {1157}
3412E and C30 Engines Piston and Rings
3500 Generator Set Engines Time Delay Relay
2002/03/01 Change to Disassembly and Assembly Manual {1157}
G3612 and G3616 Engines Inlet Air Temperature Sensor - Remove and Install
C-12 Marine Engines Fuel Filter Base - Remove
C-12 Marine Engines Fuel Filter Base - Install
C280-16 Petroleum Engine Pressure Switch
3126B Marine Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
3500 Generator Set Engines Pressure Switch
3500 Generator Set Engines Pressure Switch
3056E Industrial Engine Inlet Manifold
2002/04/01 Marine Transmission Oil Pressure Sensor Location {3323}
G3612 and G3616 Engines Turbocharger - Disassemble
3408E and 3412E Engines for Caterpillar Built Machines Camshaft
G3612 and G3616 Engines Turbocharger - Assemble
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0672 - FMI 02