Fuel Filter Base - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Apply 9S-3263 Thread Lock Compound to the threads of the fuel filter mounting stud. Apply the compound to the tapered end of the stud no more than 7.6 mm (0.30 inch) from the end.
- Install the stud and tighten to a torque of 70 ± 15 N·m (52 ± 11 lb ft).
- Inspect the condition of the O-ring seals. Replace the seals, if necessary.
- Install the O-rings on fuel filter base (4) .
Show/hide table
Illustration 1 | g00671294 |
Typical Example L. H. Engine |
- Install fuel filter base (4) with two bolts (3) and the washers.
- Connect hose assemblies (1) .
- Install the fuel temperature sensor (2) and connect the fuel temperature sensor connector.
Show/hide table
Illustration 2 | g00671364 |
Typical Example |
- Install a new fuel filter (5). Follow the instructions on the fuel filter.
Show/hide table
Illustration 3 | g00671271 |
Typical Example R. H. Engine |
Caterpillar Information System:
C-12 Marine Engines Fuel Filter Base - Remove
G3408C and G3412C Engines Carburetor Control Linkage
2002/03/01 Change to Specifications Manual {1157}
G3612 and G3616 Engines Engine Speed/Timing Sensor - Remove and Install
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Sending Unit
3500 Generator Set Engines Sending Unit - Engine Oil Pressure
3126E On-highway Engine Engine Oil Pump - Assemble
3126E On-highway Engine Engine Oil Pump - Disassemble
G3612 and G3616 Engines Ignition Wiring Harness - Remove and Install
2002/04/01 Change to Disassembly and Assembly Manual {1157}
3412E and C30 Engines Piston and Rings
3500 Generator Set Engines Time Delay Relay
C280-16 Petroleum Engine Pressure Switch
3126B Marine Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
3500 Generator Set Engines Pressure Switch
3500 Generator Set Engines Pressure Switch
3056E Industrial Engine Inlet Manifold
2002/04/01 Marine Transmission Oil Pressure Sensor Location {3323}
G3612 and G3616 Engines Turbocharger - Disassemble
3408E and 3412E Engines for Caterpillar Built Machines Camshaft
G3612 and G3616 Engines Turbocharger - Assemble
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0672 - FMI 02
3500 Engines Duplex Oil Filter - Adjust
3056E Industrial Engine Fuel Injection Nozzles