Engine Oil Pump - Disassemble
Disassembly Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 5P-7311     | Chain Puller     | 1     |
7S-7786 | Puller Leg     | 2     | |
5F-7345 | Screw     | 1     |
Start By:
- Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove the two bolts, oil pickup tube (2), and the gasket from the engine oil pump. Remove one bolt and outlet elbow (1) from the engine oil pump.
Show/hide table
Illustration 1 | g00614664 |
- Remove bolt (3) and the washer (4) .
Show/hide table
Illustration 2 | g00614677 |
- Remove idler gear (5) from shaft (6) .
Show/hide table
Illustration 3 | g00614683 |
- Remove the bearing from idler gear (5) with Tooling (A) .
- Use Tooling (A) to remove drive gear (8) from engine oil pump (7) .
Caterpillar Information System:
G3612 and G3616 Engines Ignition Wiring Harness - Remove and Install
2002/04/01 Change to Disassembly and Assembly Manual {1157}
3412E and C30 Engines Piston and Rings
3500 Generator Set Engines Time Delay Relay
2002/03/01 Change to Disassembly and Assembly Manual {1157}
G3612 and G3616 Engines Inlet Air Temperature Sensor - Remove and Install
3056E Industrial Engine Exhaust Manifold
G3612 and G3616 Engines Electronic Control Module - Remove and Install
2002/03/01 New Specification For The Minimum Fuel Pressure At The Inlet To The Fuel Transfer Pump {1274}
G3612 and G3616 Engines Integrated Combustion Sensing Module (ICSM) - Remove and Install
Setup of the Machine Security System{7631} Setup of the Machine Security System{7631}
3176C and 3196 Engines for Caterpillar Built Machines Connecting Rod
3126E On-highway Engine Engine Oil Pump - Assemble
3500 Generator Set Engines Sending Unit - Engine Oil Pressure
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Sending Unit
G3612 and G3616 Engines Engine Speed/Timing Sensor - Remove and Install
2002/03/01 Change to Specifications Manual {1157}
G3408C and G3412C Engines Carburetor Control Linkage
C-12 Marine Engines Fuel Filter Base - Remove
C-12 Marine Engines Fuel Filter Base - Install
C280-16 Petroleum Engine Pressure Switch
3126B Marine Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
3500 Generator Set Engines Pressure Switch
3500 Generator Set Engines Pressure Switch