CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
Conditions Which Generate This Code:
The signal for the primary engine speed/timing sensor is intermittent or lost.
System Response:
The Electronic Control Module (ECM) will log the diagnostic code.
- Engine shutdown
Note: The engine will shut down only if both the primary engine speed/timing sensor and the secondary engine speed/timing sensor fail.
Test Step 1. Perform the following diagnostic procedure: Engine Speed/Timing Sensor Circuit - Test
Results:
- OK - STOP
Caterpillar Information System:
C280-16 Petroleum Engine Pressure Switch
C-12 Marine Engines Fuel Filter Base - Install
C-12 Marine Engines Fuel Filter Base - Remove
G3408C and G3412C Engines Carburetor Control Linkage
2002/03/01 Change to Specifications Manual {1157}
G3612 and G3616 Engines Engine Speed/Timing Sensor - Remove and Install
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Sending Unit
3500 Generator Set Engines Sending Unit - Engine Oil Pressure
3126E On-highway Engine Engine Oil Pump - Assemble
3126E On-highway Engine Engine Oil Pump - Disassemble
G3612 and G3616 Engines Ignition Wiring Harness - Remove and Install
2002/04/01 Change to Disassembly and Assembly Manual {1157}
3500 Generator Set Engines Pressure Switch
3500 Generator Set Engines Pressure Switch
3056E Industrial Engine Inlet Manifold
2002/04/01 Marine Transmission Oil Pressure Sensor Location {3323}
G3612 and G3616 Engines Turbocharger - Disassemble
3408E and 3412E Engines for Caterpillar Built Machines Camshaft
G3612 and G3616 Engines Turbocharger - Assemble
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0672 - FMI 02
3500 Engines Duplex Oil Filter - Adjust
3056E Industrial Engine Fuel Injection Nozzles
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0672 - FMI 08
3056E Industrial Engine Cylinder Head Valves