Engine Speed/Timing Sensor - Remove and Install
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 切断供电。
- 从传感器 (4) 上断开线束 ( 3)。
- 卸下螺栓 (1) 和夹子 ( 2)。
- 卸下此传感器。
Show/hide table
| |
| 图 1 | g00876380 |
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 检查 O 形密封圈有无损坏。 必要时，更换密封圈。
- 安装转速/正时传感器 ( 4)。
注: 将转速/正时传感器在壳体孔中安装到位。
- 安装夹子 (2) 和螺栓 ( 1)。
- 将线束 (3)连接至传感器。
- 连接电源。
Show/hide table
|
| |
| 图 2 | g00876380 |
Caterpillar Information System:
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Sending Unit
3500 Generator Set Engines Sending Unit - Engine Oil Pressure
3126E On-highway Engine Engine Oil Pump - Assemble
3126E On-highway Engine Engine Oil Pump - Disassemble
G3612 and G3616 Engines Ignition Wiring Harness - Remove and Install
2002/04/01 Change to Disassembly and Assembly Manual {1157}
3412E and C30 Engines Piston and Rings
3500 Generator Set Engines Time Delay Relay
2002/03/01 Change to Disassembly and Assembly Manual {1157}
G3612 and G3616 Engines Inlet Air Temperature Sensor - Remove and Install
3056E Industrial Engine Exhaust Manifold
G3612 and G3616 Engines Electronic Control Module - Remove and Install
2002/03/01 Change to Specifications Manual {1157}
G3408C and G3412C Engines Carburetor Control Linkage
C-12 Marine Engines Fuel Filter Base - Remove
C-12 Marine Engines Fuel Filter Base - Install
C280-16 Petroleum Engine Pressure Switch
3126B Marine Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
3500 Generator Set Engines Pressure Switch
3500 Generator Set Engines Pressure Switch
3056E Industrial Engine Inlet Manifold
2002/04/01 Marine Transmission Oil Pressure Sensor Location {3323}
G3612 and G3616 Engines Turbocharger - Disassemble
3408E and 3412E Engines for Caterpillar Built Machines Camshaft