Sending Unit - Engine Oil Pressure
Show/hide table
Illustration 1 | g00505955 |
Note: During the calibration check, tap the sending unit for the engine oil pressure. Take readings on decreasing pressure.
Show/hide table
Calibration Chart | |
Pressure | Test Resistance |
|
0 to 3 ohms |
|
5 to 16 ohms |
|
90 ohms |
Caterpillar Information System:
3126E On-highway Engine Engine Oil Pump - Assemble
3126E On-highway Engine Engine Oil Pump - Disassemble
G3612 and G3616 Engines Ignition Wiring Harness - Remove and Install
2002/04/01 Change to Disassembly and Assembly Manual {1157}
3412E and C30 Engines Piston and Rings
3500 Generator Set Engines Time Delay Relay
2002/03/01 Change to Disassembly and Assembly Manual {1157}
G3612 and G3616 Engines Inlet Air Temperature Sensor - Remove and Install
3056E Industrial Engine Exhaust Manifold
G3612 and G3616 Engines Electronic Control Module - Remove and Install
2002/03/01 New Specification For The Minimum Fuel Pressure At The Inlet To The Fuel Transfer Pump {1274}
G3612 and G3616 Engines Integrated Combustion Sensing Module (ICSM) - Remove and Install
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Sending Unit
G3612 and G3616 Engines Engine Speed/Timing Sensor - Remove and Install
2002/03/01 Change to Specifications Manual {1157}
G3408C and G3412C Engines Carburetor Control Linkage
C-12 Marine Engines Fuel Filter Base - Remove
C-12 Marine Engines Fuel Filter Base - Install
C280-16 Petroleum Engine Pressure Switch
3126B Marine Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
3500 Generator Set Engines Pressure Switch
3500 Generator Set Engines Pressure Switch
3056E Industrial Engine Inlet Manifold
2002/04/01 Marine Transmission Oil Pressure Sensor Location {3323}