Fuel Filter Base - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 2P-8250     | Strap Wrench Assembly     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Use Tool (A) to remove fuel filter (5) .
Show/hide table
Illustration 1 | g00671271 |
Typical Example R. H. Engine |
Show/hide table
Illustration 2 | g00671294 |
Typical Example L. H. Engine |
- Disconnect the fuel temperature sensor connector.
- Remove fuel temperature sensor (2) .
Show/hide table
Illustration 3 | g00671364 |
Typical Example |
- Remove O-ring seal (6) from fuel temperature sensor (2) .
- Disconnect hose assemblies (1). Plug all openings immediately.
- Remove two bolts (3) and the washers.
- Remove fuel filter base (4) and the two O-ring seals.
- Remove the fuel filter mounting stud from the fuel filter base, if necessary.
Caterpillar Information System:
G3408C and G3412C Engines Carburetor Control Linkage
2002/03/01 Change to Specifications Manual {1157}
G3612 and G3616 Engines Engine Speed/Timing Sensor - Remove and Install
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Sending Unit
3500 Generator Set Engines Sending Unit - Engine Oil Pressure
3126E On-highway Engine Engine Oil Pump - Assemble
3126E On-highway Engine Engine Oil Pump - Disassemble
G3612 and G3616 Engines Ignition Wiring Harness - Remove and Install
2002/04/01 Change to Disassembly and Assembly Manual {1157}
3412E and C30 Engines Piston and Rings
3500 Generator Set Engines Time Delay Relay
2002/03/01 Change to Disassembly and Assembly Manual {1157}
C-12 Marine Engines Fuel Filter Base - Install
C280-16 Petroleum Engine Pressure Switch
3126B Marine Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
3500 Generator Set Engines Pressure Switch
3500 Generator Set Engines Pressure Switch
3056E Industrial Engine Inlet Manifold
2002/04/01 Marine Transmission Oil Pressure Sensor Location {3323}
G3612 and G3616 Engines Turbocharger - Disassemble
3408E and 3412E Engines for Caterpillar Built Machines Camshaft
G3612 and G3616 Engines Turbocharger - Assemble
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0672 - FMI 02
3500 Engines Duplex Oil Filter - Adjust