3056E Industrial Engine Caterpillar

Exhaust Manifold

Usage:

Show/hide table




Illustration 1	g00943878
Two-piece exhaust manifold

Show/hide table




Illustration 2	g00944336
Three-piece exhaust manifold

Note: New bolts have sealant to the first 13 mm (0.512 inch) of the threads. In order to reuse the old bolts, clean the old sealant from the bolts and apply 4C-9507 Retaining Compound to the bolts.

Tighten the bolts for the exhaust manifold in the numerical sequence to the following starting torque. ... 13 N·m (10 lb ft)

Tighten the bolts in a numerical sequence to the following final torque. ... 33 N·m (24 lb ft)

Caterpillar Information System:

G3612 and G3616 Engines Electronic Control Module - Remove and Install

2002/03/01 New Specification For The Minimum Fuel Pressure At The Inlet To The Fuel Transfer Pump {1274}

G3612 and G3616 Engines Integrated Combustion Sensing Module (ICSM) - Remove and Install

Setup of the Machine Security System{7631} Setup of the Machine Security System{7631}

3176C and 3196 Engines for Caterpillar Built Machines Connecting Rod

G3612 and G3616 Engines Water Pump Pressure Switch - Remove and Install

UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies User Interface for Multiple Module Unit

3412E and C30 Engines Connecting Rod

SR4 Generator with VR3 or VR4 Voltage Regulator Coupling - Remove

2002/03/01 Caterpillar Electronic Technician (ET) Software Is Now Available For G3400 Engines And G3500 Engines That Are Equipped With An Electronic Ignition System (EIS) Or Air/Fuel Ratio Controls {0785}

C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Programming Parameters

UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Modes Of Operation

G3612 and G3616 Engines Inlet Air Temperature Sensor - Remove and Install

2002/03/01 Change to Disassembly and Assembly Manual {1157}

3500 Generator Set Engines Time Delay Relay

3412E and C30 Engines Piston and Rings

2002/04/01 Change to Disassembly and Assembly Manual {1157}

G3612 and G3616 Engines Ignition Wiring Harness - Remove and Install

3126E On-highway Engine Engine Oil Pump - Disassemble

3126E On-highway Engine Engine Oil Pump - Assemble

3500 Generator Set Engines Sending Unit - Engine Oil Pressure

3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Sending Unit

G3612 and G3616 Engines Engine Speed/Timing Sensor - Remove and Install

2002/03/01 Change to Specifications Manual {1157}