Track Carrier Roller - Install
Installation Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
(A)     | 8T-5255     | Hydraulic Jack     | 2     |
- Be sure that the shaft of the track carrier roller and the bore in the mounting bracket on the undercarriage frame are clean and free of dirt.
- Put the track carrier roller in position in the mounting bracket. Adjust the carrier roller until distance (B), the distance between the outside face of the mounting bracket and the carrier roller is 7.0 ± 0.5 mm (.28 ± .02 inch).
Show/hide table
Illustration 1 | g00365374 |
- After adjusting the position of the carrier roller in the mounting bracket, tighten bolt (2) .
Show/hide table
Illustration 2 | g00481121 |
- Be sure that the carrier roller rotates smoothly by hand. Slowly lower the track assembly to the carrier roller with Tooling (A) .
- Tighten the tension of the track. Refer to Operation and Maintenance Manual, "Track Adjustment - Adjust" for more information.
Caterpillar Information System:
2001/11/01 Changes were made in the Communication Link for the Marine Monitoring System II (MMS II) and the Generator Monitoring System (GMS) {7490}
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller - Remove
3126B and 3126E On-highway Engines 0128-04 Secondary Fuel Level voltage low
3126B and 3126E On-highway Engines 0128-03 Secondary Fuel Level voltage high
Power Module Switchgear (Low Voltage and Medium Voltage) Initial Startup Safety Check
Power Module Switchgear (Low Voltage and Medium Voltage) Installation
3126B and 3126E On-highway Engines 0096-04 Fuel Level voltage low
Power Module Switchgear (Low Voltage and Medium Voltage) Handling
Power Module Switchgear (Low Voltage and Medium Voltage) Storage
Power Module Switchgear (Low Voltage and Medium Voltage) Receiving Inspection
G3408 and G3412 Engines Engine Speed/Timing Sensor - Clean/Inspect
3054 and 3056 Engines 520 Generator Set Control Panel Factory Default Values of Configuration Parameters
Power Module Switchgear (Low Voltage and Medium Voltage) Initial Startup Procedure
3126 Truck Engine Flywheel Housing
Power Module Switchgear (Low Voltage and Medium Voltage) General Maintenance Information
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller - Disassemble
C7 and C9 On-Highway Engines 0186-04 PTO Engine Shutdown Switch voltage low
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller - Assemble
3126 Truck Engine Engine Oil Pan
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Roller - Remove
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Roller - Disassemble
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Roller - Assemble
3126B and 3126E On-highway Engines 0186-14 PTO Engine Shutdown Switch Occurrence (47)
SCT673 Truck Mounted PumperPOD Hydraulic System Oil Filter - Replace - Gear Case