Handling
Show/hide table
 |
Improper handling of the equipment may result in personal injury or death or damage to the equipment. Have qualified personnel move the equipment if replacement of the switchgear is necessary. Be careful and move the equipment slowly. Ensure that the equipment is not handled in a rough manner. Bodily contact with electrical potential will cause personal injury or death. |
- After the switchgear has been inspected, determine whether the shipment is complete. Determine whether the shipment is correct.
- Handle the switchgear with care. Rough handling may cause damage to internal components and to external components.
- Avoid scratching or marring of the finish of the switchgear. Imperfections in the finish will allow rusting to begin.
- When you ship the power module, the generator circuit breaker must be in the CONNECTED position.
Caterpillar Information System:
Power Module Switchgear (Low Voltage and Medium Voltage) Storage
Power Module Switchgear (Low Voltage and Medium Voltage) Receiving Inspection
G3408 and G3412 Engines Engine Speed/Timing Sensor - Clean/Inspect
3054 and 3056 Engines 520 Generator Set Control Panel Factory Default Values of Configuration Parameters
3126B and 3126E On-highway Engines 0096-03 Fuel Level voltage high
3054 and 3056 Engines 520 Generator Set Control Panel Wiring Diagrams
385B Excavator Disconnecting Hydraulic Hoses and Lines
3116 Truck Engine Charging System - Test
3512B and 3512C Engines For Caterpillar Built Machines Heating System
3116 Truck Engine Piston Ring Groove - Inspect
SCT673 Truck Mounted PumperPOD Hydraulic Oil Sample - Obtain - Gear Case
3054 and 3056 Marine Generator Set Engines Exhaust Manifold
3126B and 3126E On-highway Engines 0096-04 Fuel Level voltage low
Power Module Switchgear (Low Voltage and Medium Voltage) Installation
Power Module Switchgear (Low Voltage and Medium Voltage) Initial Startup Safety Check
3126B and 3126E On-highway Engines 0128-03 Secondary Fuel Level voltage high
3126B and 3126E On-highway Engines 0128-04 Secondary Fuel Level voltage low
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller - Remove
2001/11/01 Changes were made in the Communication Link for the Marine Monitoring System II (MMS II) and the Generator Monitoring System (GMS) {7490}
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller - Install
Power Module Switchgear (Low Voltage and Medium Voltage) Initial Startup Procedure
3126 Truck Engine Flywheel Housing
Power Module Switchgear (Low Voltage and Medium Voltage) General Maintenance Information
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller - Disassemble